INSTALLATION INSTRUCTIONS
1. If possible avoid placing the appliance near cookers, radiators or in direct
sunlight as this will cause the compressor to run for long periods. If installed next
to a source of heat or refrigerator, maintain the following minimum side
clearances:
2. Make sure that sufficient room is provided around the appliance to ensure free
air circulation. Ideally, ensure you allow gaps as shown in the below diagram.
3. The appliance should be located on a smooth surface.
4. Refer to "Cleaning and Care" section to prepare your appliance for use.
5. If the freezer is installed in unheated areas, garages etc., in cold
weather condensation may form on the outer surfaces.
This is quite normal and is not a fault. Remove the condensation by
wiping with a dry cloth.
4
To Next Page
