What to do if my Beko WTK72041B Washer does not drain water?
If your Beko washer isn't draining, the water drain hose might be clogged or twisted, so clean or flatten it. Alternatively, the pump filter could be clogged, requiring cleaning.
What to do if my Beko WTK72041B won't start after closing the door?
If your Beko washer program doesn't start after closing the door, make sure you press the Start / Pause / Cancel button. Also, if you have loaded too much laundry, it may be difficult to close the loading door, so reduce the amount of laundry and ensure the door is closed properly.
Why is my Beko Washer leaking water from the bottom?
If water is leaking from the bottom of your Beko washing machine, the water drain hose might be clogged or twisted, so clean or flatten it. Alternatively, the pump filter could be clogged and needs cleaning.
Why is there detergent residue in the detergent drawer of my Beko Washer?
Detergent residue in the drawer of your Beko washer may be caused by putting detergent in a wet drawer, so dry the drawer before adding detergent. The detergent may have gotten damp, so keep detergents closed in a humidity-free environment and avoid excessive temperatures. Low water pressure or blocked holes in the detergent compartment can also cause this issue, so check the water pressure and clean the holes if they are clogged. Avoid mixing the softener with detergent and wash the dispenser with hot water.
Why does my Beko Washer vibrate and make noise?
Your Beko washer may vibrate or make noise due to several reasons. The machine might be unbalanced, so adjust the feet to level it. A hard substance might have entered the pump filter, requiring you to clean it. Ensure the transportation safety bolts are removed. The laundry quantity might be too little, so add more, or the machine might be overloaded, so take some out. Also, make sure the machine isn't leaning on anything.
Why does my Beko WTK72041B Washer take longer than specified in the manual?
The wash cycle on your Beko washer might be taking longer than usual due to several factors. The water pressure could be low, causing the machine to wait until it takes in enough water. Low voltage or low input water temperature can also extend the washing time. Additionally, the number of rinses or the amount of rinse water might have increased, or excessive foam might have occurred due to too much detergent.
What to do if my Beko WTK72041B Washer stops shortly after starting?
If your Beko washer stopped temporarily shortly after the program started, it might be due to low voltage. It will resume running when the voltage restores to the normal level.
Why can't I start or select a programme on my Beko WTK72041B Washer?
Your Beko washing machine may have switched to self-protection mode due to a supply problem like line voltage or water pressure. To cancel the current program, turn the Programme Selection knob to select another program.
Why is my Beko Washer directly discharging the water it takes in?
If your Beko washer is immediately discharging the water it takes in, the draining hose might not be at an adequate height. Connect the water draining hose as described in the operation manual.
What to do if my Beko Washer enters standby mode or doesn't take in water?
If your Beko washer enters standby mode or doesn't take in water, check if the tap is turned off and turn it on. Ensure the water inlet hose isn't bent and flatten it if it is. Clean the water inlet filter if it's clogged. Also, make sure the loading door is closed. Finally, check the water connection and ensure water is supplied; if it was cut off, press the Start/Pause key to resume operation.
To Next Page
General
