EasyManua.ls Logo

Beko WTK74011W - User Manual

Beko WTK74011W
44 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Washing Machine
User Manual
WTK74011W
2820528323_EN/ 31-03-20.(12:32)
Document Number :

Table of Contents

Questions and Answers

  • R
    Robert MartinezSep 10, 2025
    Why do stains persist or laundry not whiten after washing in my Beko WTK74011W Washer?
    • S
      Sarah JohnsonSep 10, 2025
      If stains persist or laundry isn't whitened after washing in your Beko Washer, it could be due to insufficient detergent. Use the recommended amount. Overloading the machine can also cause this; do not load in excess. The wrong programme and temperature selection can also lead to poor results; select the proper settings. Using the wrong type of detergent can also be a factor; use original detergent appropriate for the machine. Too much detergent can also be a problem; put detergent in the correct compartment and don't mix bleaching agents and detergent.
  • P
    Paula GlassAug 22, 2025
    How to open a Beko WTK74011W Washer door that is stuck?
    • D
      donna79Aug 23, 2025
      If the loading door of your Beko Washer cannot be opened, it could be due to a few reasons. The door lock might be activated because of the water level; drain the water by running the Pump or Spin programme. The machine might be heating water or at the spinning cycle; wait until the programme completes. If the child lock is engaged, wait a couple of minutes after the programme ends for deactivation. The door might also be stuck due to pressure; grab the handle and push and pull the door to release it.
  • D
    David FrancoAug 25, 2025
    Why is my Beko WTK74011W Washer leaking water from the bottom?
    • C
      Curtis SolisAug 25, 2025
      If you notice water leaking from the bottom of your Beko Washer, it might be due to a clogged or twisted water drain hose. Try cleaning or flattening the hose. Additionally, the pump filter could be clogged, so make sure to clean that as well.
  • M
    mooregregoryAug 26, 2025
    Why won't my Beko Washer go to the spinning step?
    • K
      Kim KingAug 26, 2025
      If your Beko Washer isn't switching to the spinning step, it could be due to an unbalanced load. The automatic unbalanced load detection system may be activated. Also, the machine won't spin if water isn't drained completely; check the filter and the draining hose. Excessive foam from too much detergent could also be the cause; use the recommended amount of detergent.
  • D
    Deborah NelsonAug 27, 2025
    What to do if my Beko WTK74011W Washer enters standby mode or doesn't take in water?
    • T
      tduncanAug 28, 2025
      If your Beko Washer enters standby mode or doesn't take in water, check if the tap is turned on and ensure the water inlet hose isn't bent; flatten it if it is. Also, the water inlet filter might be clogged, so clean it. Ensure the loading door is closed properly. If the water connection is wrong or water is cut off, check the connection and press the Start/Pause key once the water supply resumes.
  • A
    aballardAug 29, 2025
    Why won't my Beko WTK74011W programme start after closing the door?
    • S
      Stephen HesterAug 29, 2025
      If your Beko Washer programme doesn't start after closing the door, make sure you've pressed the Start / Pause / Cancel button. Also, excessive loading can make it difficult to close the door properly; reduce the amount of laundry and ensure the door is closed correctly.
  • D
    David NguyenSep 18, 2025
    Why does my Beko WTK74011W Washer immediately discharge the water it takes in?
    • P
      Peter MooreSep 18, 2025
      If your Beko Washer immediately discharges the water it takes in, the draining hose might not be at an adequate height. Connect the water draining hose as described in the operation manual.
  • C
    Cynthia JacksonSep 12, 2025
    Why is foam overflowing from the detergent drawer of my Beko WTK74011W?
    • M
      Melissa JonesSep 12, 2025
      Foam overflowing from the detergent drawer of your Beko Washer is likely due to using too much detergent. To resolve this, mix 1 tablespoonful of softener with ½ liter of water and pour it into the main wash compartment of the detergent drawer. Also, ensure you put detergent into the machine suitable for the programmes and maximum loads.
  • S
    Susan MathisSep 8, 2025
    Why is my laundry turning gray after washing in my Beko WTK74011W?
    • J
      John JacksonSep 8, 2025
      Laundry may turn gray after washing in your Beko Washer due to insufficient detergent used over a long period. Use the recommended amount of detergent. Washing at low temperatures for a long time can also cause this; select the proper temperature for the laundry. Insufficient detergent with hard water can also lead to graying; use the recommended amount. Using too much detergent can also contribute to this issue; use the recommended amount appropriate for water hardness and laundry.
  • D
    Dwayne WatkinsSep 5, 2025
    Why is there detergent residue in my Beko WTK74011W Washer detergent drawer?
    • A
      Alexa JohnsonSep 5, 2025
      Detergent residue in the detergent drawer of your Beko Washer can occur if the detergent is put in a wet drawer; dry the drawer before adding detergent. The detergent may have gotten damp; keep detergents closed in a humidity-free environment and avoid excessive temperatures. Low water pressure can also be a factor; check the water pressure. The detergent in the main wash compartment may have gotten wet while prewash water was taken in, or the holes of the compartment are blocked; check and clean them if clogged. There could also be a problem with the detergent drawer valves. Ensure detergent isn't mixed with softener, and clean the dispenser with hot water. Regular drum cleaning may also be needed.

Summary

General Safety Instructions

1.1 Life and Property Safety

Guidelines to prevent injuries and material damage risks during product usage.

1.2 Childrens Safety

Precautions for safe use by children and keeping them away from the appliance.

1.3 Electrical and Hot Surface Safety

Instructions to prevent electric shock and warnings about hot surfaces during operation.

Environmental and Intended Use

2.1 Environmental Compliance

Information on product compliance with the Waste Electrical and Electronic Equipment Directive.

2.2 Package Information

Details on the recyclable nature of packaging materials and disposal instructions.

3 Intended Use

Specifies the intended domestic use of the washing machine and limitations.

Your Product Details

4.1 Overview

Visual identification and labeling of the main components of the washing machine.

4.2 Package Contents

List of items included in the product packaging for setup and initial use.

4.3 Technical Specifications

Key technical data and specifications of the washing machine model.

4.4 Installation

Detailed instructions and guidelines for installing the washing machine safely and correctly.

4.5 Preparation

Steps and advice for preparing laundry and the machine before washing.

4.6 Operating the Product

Guidance on using the control panel, selecting programmes, and operating the machine.

4.7 Maintenance and Cleaning

Procedures for regular cleaning and maintenance to ensure product longevity.

Troubleshooting Common Issues

Programme Start & Selection Issues

Solutions for programmes not starting, being unselectable, or machine standby issues.

Water Drainage & Noise Issues

Troubleshooting for water not draining, leaks, vibration, and noise problems.

Machine Operation & Performance

Resolving issues like machine stopping, longer wash times, or timer not counting down.

Washing Quality & Detergent Issues

Addressing poor washing performance, stains, smell, and detergent-related problems.

Rinse, Stiffness & Softener Issues

Solutions for ineffective rinsing, stiff laundry, and softener scent problems.

Foam and Wet Laundry Issues

Troubleshooting for excessive foam, overflowing, and laundry remaining wet.

Guarantee and Service Information

Standard Guarantee Terms

Details on the manufacturer's guarantee, coverage, exclusions, and important notes.

How to Obtain Service

Instructions on how to get service, contact support, and register products.

Beko WTK74011W Specifications

General IconGeneral
Door hingeLeft
Motor typeBrushless
Water fillCold
Control typeRotary
Loading typeFront-load
Drum materialStainless steel
Product colorWhite
Built-in displayYes
Custom panel-readyNo
Door opening angle170 °
Outlet hose length1.3 m
Appliance placementFreestanding
Feet adjustment15 mm
Drum capacity7 kg
Cycle time (max)207 min
AquaStop function-
Delay start (max)9 h
Residual moisture53 %
Spin-drying classB
Maximum spin speed1400 RPM
Noise level (spin)72 dB
Noise level (wash)- dB
Number of washing programs15
Maximum water flow pressure1000 kPa
Minimum water flow pressure100 kPa
Cycle time (quick washing program)28 min
Current10 A
Connected load2200 W
Power plug typeType G
AC input voltage230 V
AC input frequency50 Hz
Energy efficiency scaleA to G
Power consumption (off)0.5 W
Power consumption (standby)1 W
Water consumption per cycle45 L
Energy consumption washing per cycle0.685 kWh
Energy efficiency index (EU 2017/1369)1.04
Package depth560 mm
Package width650 mm
Package height880 mm
Package weight68000 g
Hose diameter20 mm
Required toolsStandard tool box
Paper packaging weight10 g
Plastic packaging weight178 g
Harmonized System (HS) code84501190
Expanded Polystyrene (EPS) packaging weight760 g
Weight and Dimensions IconWeight and Dimensions
Depth550 mm
Width600 mm
Height840 mm
Weight67000 g
Door opening diameter300 mm

Related product manuals