Belarus 3522.5 - Page 20

3522.5-0000010 РЭ
21
Table 1.1 finished
Parameter title
(characteristics)
Parameter value for the tractor
“BELARUS-3522.5”
19 Hydraulic system:
а) pump displacement at crankshaft
rated speed, l/min от 0 до 120
b) safety valve operation pressure, MPa 20,5±0,5
c) conventional volume factor, not less
than 0,75
20 Working equipment:
а) rear power take-off shaft:
rated speed of PTO shaft end exten-
sion in the following modes, min
-1
:
- stage I – main mode at 2000 min
-1
of engine crankshaft speed
1000 (1100)
9)
- stage II – economy mode:
at 1440 min
-1
of engine crankshaft
speed 1000 (1530)
9)
- stage III – additional mode: at 1500
min
-1
of engine crankshaft speed 540 (790)
7)
b) front power takeoff shaft:
rated speed of PTO shaft end extension
(at 2160 min
-1
of engine crankshaft), min
-1
1000 (1017)
9)
c) rear lift linkage:
1) loading capacity of rear lift linkage on
suspension axis, kg, not less than 10000
2) time for raising rear lift linkage from
lowermost position into uppermost position
with test load on suspension axis, sec., not
more than 6,5
d) front lift linkage:
1) loading capacity of front lift linkage
on suspension axis, kg, not less than 5000
2) ballast weight, mounted on FLL, kg 1320
e) drawbar hitch: In unit 5 “Implement coupling”
____________________________________
1)
When the tractor is completed with front supplementary wheels with twinning
mechanism, rear supplementary wheels with spacers and front ballast weights with
the mass of 1320 kg.
2)
Engine parameters, not specified within these specifications, shall meet “DEUTZ”
documents.
3)
For referential use.
4)
On tyres 710/70R42.
5)
It is assumed to use front tyres 600/65R34.
6)
It is assumed to use rear tyres 710/70R42.
7)
At 2200 min
-1
of engine crankshaft speed.
https://tractormanualz.com/