3522.5-0000010 OM
244
Figure 5.3.2 – Rear lift linkage diagramm of “LL-4” type
ATTENTION: AFTER COUPLING OF A TRACTOR, EQUIPPED WITH GRIPPER
TOOL MANUFACTURED BY MTW, WITH MOUNTED OR SEMIMOUNTED IMPLE-
MENTS, LOCK THE GRIPPERS OF THE LOWER DRAWBARS OF REAR LIFT LINK-
AGE BY MEANS OF PIN 1 (FIGURE 5.3.3а) WITH RING 2!
ATTENTION! AFTER UNCOUPLING OF THE IMPLEMENT FROM THE TRACTOR
IT IS NESESSARY TO DRAW THE FORELOCK 5 OUT OF THE AXIS 6 OF THE IMPLE-
MENT (FIGURE 5.3.3a), FIXING HINGED JOINT 4 ON THE AXIS OF THE IMPLEMENT,
AND THE PIN 1 WITH THE RING 2 OUT OF THE GRIPPER, AND THEN RISE THE
HANDLE OF THE GRIPPER 3 UP TO THE STOP 6. SET THE PIN AND THE FORELOCK
AS SHOWN IN FIGURE 5.3.3 b!
https://tractormanualz.com/
To Next Page
