3522.5-0000010 OM
246
5.3.3 Front three-point lift linkage
Front lift linkage with dimensions corresponding to standard size “LL-2”, is similar on
critical parameters to the rear lift linkage. Front lift linkage is designed for the following pur-
poses:
- forming of combined units (tiller is in front of the machine, and seeder is behind
and etc.);
- forming of echelon linkage mounting (front and side-cut mower and etc.);
- transportation of implements detached from the combined units located in the rear
end during long-distance transportation;
- for mounting of front hanging ballast.
Front lift linkage of a tractor is used with tilling machines only in a propelling condi-
tion, FLL is not designed for use with tilling machines on reverse.
IT IS PROHIBITED TO OPERATE FLL WITH LOGGING BLADES, AND FOR
JACKING OF TACTOR FRONT ELEMENT.
Note – Rules on coupling of implements with FLL, guidance on changing of FLL op-
erating position into the transport position, and also the general information about the de-
sign of FLL are set forth in subsection 3.20 “Front lift linkage”.
Figure 5.3.4 – Front lift linkage diagram
Scheme of installation of linkage-mounted ballast weights assembled with mounted
bracket to FLL is shown in Figure 5.3.4а. Information about installation of linkage-mounted
ballast weights to FLL is shown in Table 5.2а.
Figure 5.3.4а – Scheme of installation of linkage-mounted ballast weights to FLL
https://tractormanualz.com/
To Next Page
