136 K-FRAME — User Manual
Section 4 — Video Mix/Effects
Smoke — provides a dark gray, disintegrating trail that resembles
smoke.
Fire — provides a red, disintegrating flame effect.
Paint — allows you to apply or “paint” the current image anywhere on
the display using the joystick.
Erase — allows you to erase the current effect using the joystick.
Output Recursive Modes
Select any of the four modes in the Output Recursive Mode pane to create
keyer special effects. Each mode displays specific controls for parameters
when selected.
Motion Decay Mode
Causes motion in the image to leave a blurred remnant in the area from
which it was removed.
Appearance button — displays the “Pic” or Picture Decay value from the soft
knob data pad.
Wind button — displays the Direction and Velocity (speed) values from the
soft knob data pads.
Loop button —
• ON — starts the recursive effect
•
OFF — stops the recursive effect and returns to live video
Keyframe Reset button — used to control when images are frozen, only avail-
able when the Keyframe mode button is selected as the Strobe Type.
• ON — A keyframe triggers a reset, followed by a new single strobe. It
resets that loop by creating a new frozen image at each keyframe that
has the
Keyframe Reset button on.
•
OFF — does not change the frozen image at each keyframe
Force Strobe — When an effect passes over or stops on a keyframe, a single
strobe event is triggered. While the effect sits on a keyframe with keyframe-
strobe on, no additional events are triggered. The “history” of the prior
single event is discarded, and a single strobe is triggered again.
• ON — accumulates a field/frame of video within the Output Recursive
loop.
•
OFF — No action is taken.
To Next Page
