166 K-FRAME — User Manual
Section 5 — Switcher Control
Remove a Macro Attachment
1. Press the Delete button on the System Bar.
2. Press the Show button so that panel buttons with macros attached blink
low tally.
3. Without selecting a macro register, press the blinking button that has
the attachment you wish to remove. The blinking button will turn off.
4. Press Show to turn off the mode.
To remove all macros, go to the Macros Attach menu and select Remove All
Macros button (warning will appear to confirm remove all).
Append to a Macro
1. Turn on Macro append mode by holding down the Record button for a
full second. The button will turn blue and blink slowly until a macro is
selected.
2. Press the macro register button on the delegated keyer row of an
existing macro to which you wish to append additional steps. The
Record button will remain colored blue and blink fast, indicating a
Macro is being recorded.
3. Perform the additional steps using the Control Panel and/or the
menus.
4. Complete the append by pressing the blinking Record button, or
pressing the blinking keyer row macro register button.
K-Frame Karrera Macro Operations
Macro Control Button Group
The Macro Control Button group on the System Bar area has eight buttons.
These controls are located above the PGM
PST stripe, at the far right of the
System Bar area, as shown in (
Figure 78). Pressing the Macro Ctrl (Control)
To Next Page
