Bell B35E 6X6 ADT User Manual

SERVICE AND CHECKS
10 HOURLY OR DAILY SERVICE AND CHECKS
Daily Oscillation Joint Procedure
1. Park machine on level ground.
2. Apply the park brake.
3. Raise the bin fully.
4. Install the Bin Prop.
5. Switch off the engine.
6. Wipe grease nipple.
7. Fill the oscillation joint with grease until ejected
grease is visible at o-ring seals A and B.
8. Remove the Bin Prop.
9. Start the engine and lower the bin.
10. Fill the oscillation joint with grease until ejected
grease is visible at o-ring seals C and D.
Hydraulic Checks
Check Hydraulic Oil Level
Ensure that the machine is parked on level ground and
away from any overhead objects that might interfere with
the movement of the bin.
Ensure that the park brake is activated whilst check-
ing oil levels. Oil levels are to be checked before en-
gine start up and can change after start up due to
accumulator charging and oil temperatures.
Tools and Equipment Required
• 50 mm spanner
Checking oil level on the CDU
1. Turn key on, enter driver’s identification code
and wait for CDU to light up.
2. Press and hold button B down to enter into
service mode.
3. Enter code.
4. Select menu button or button E.
1
6
4
E
#
A
D
T
'
S
&
H
A
U
L
E
R
S
O
P
E
R
A
T
O
R
'
S
M
A
N
U
A
L

Bell B35E 6X6 ADT Specifications

General

Brand	Bell
Model	B35E 6X6 ADT
Category	Trucks
Language	English