Bell B40E 6X6 ADT User Manual

OPERATION
OPERATING COMPONENTS
Cold Start Warning Light
Do not start the engine until the cold start warning light
(1) extinguishes.
Damage to the engine could occur if this caution is
ignored.
The cold start function is automatic.
When the ignition is switched on and the engine
coolant temperature is below 15°C (59°F), the
warning light illuminates.
When it is safe to start the engine, the cold start
warning light extinguishes.
Retarder Light
The retarder light (8) is activated when either the
brake retarder or engine retarder is activated.
Right Turn Indicator Light
The right turn indicator light (9) will flash when the
steering column switch is moved to indicate a right
turn.
If the hazard switch is ON both direction indicators
flash with the steering column switch in the OFF
position. When the steering column switch is moved
to the right turn position, the right hand side
indicator lights will flash while the left hand side
indicator lights will be ON continuously.
Transmission Fault Warning Light
If the transmission fault warning light illuminates, the
machine must be stopped immediately using only the
service brake and NOT the gear shift control.
For some problems, diagnostic codes may be registered
without the ECU activating the DNS warning light.
Whenever there is a transmission related concern,
consult BELL EQUIPMENT Product Support.
The electronic control system is programmed to
inform the operator of a problem with the
transmission system and automatically take action
to protect the operator, machine and transmission.
When the Transmission Control Unit (TCU) detects
a “Do Not Shift” (DNS) condition, the ECU restricts
shifting, turns on the DNS warning light and
registers a diagnostic code.
DEF (Diesel Exhaust Fluid) - Adblue
Warning
1
0
0
E
#
A
D
T
'
S
&
H
A
U
L
E
R
S
O
P
E
R
A
T
O
R
'
S
M
A
N
U
A
L

Bell B40E 6X6 ADT Specifications

General

Brand	Bell
Model	B40E 6X6 ADT
Category	Trucks
Language	English