Bell Dashboard 300 - Set Maintenance Reminder Interval; Set the Clock; Test Installation and Operation

programming the computer
6
STEP 4: Set Distance for Maintenance Reminder– After setting age and weight, the preset number of 600
km (or miles) will ash. Press the RIGHT button to select 200, 400, 600 or 800 km (or mile) maintenance interval,
then press the LEFT button to conrm. When your odometer (ODO) reaches the selected distance interval, the
wrench icon ( ) will ash, reminding you to service your bicycle (check tires and other parts for wear, lubricate
chain, etc…). Press the LEFT button to stop the wrench icon ( ) from ashing.
STEP 5: Set the Clock– The clock function will appear at the bottom of the screen. Press and hold the LEFT
button for 3 seconds to get a ashing "24H" symbol. Press the RIGHT button to select between 12 and 24 hour
format. Press the LEFT button to conrm. Next, the hour digits will start to ash. Use the RIGHT button to select the
hour and press the LEFT button to conrm. Repeat for minutes digits. Press the LEFT button once more to set the
clock. Press the RIGHT button to enter ODO mode.
STEP 6: Test to Ensure Proper Installation– Now that the computer is programmed, insert it into the
bracket. Spin the front wheel. The speed tendency icon in the upper left corner of the screen should be turning as
the computer starts recording data (Refer to Troubleshooting in case of problems).