Belling 900Ei - Commissioning the Appliance; Operation Checks

COMMISSIONING
Check the operation of electrical components
Clock Programmer/Minute Minder
Check functions as described in the User Guide.
Oven light & Convection fan
Open the main oven door. Turn the main oven control knob to the defrost setting. Check the oven light
and convection fan both come on. Turn control knob back to ‘OFF’ position.
Cooling Fan
Open the grill door. Turn the grill control knob to the full power setting . Check that the cooling fan
operates. Turn control knob back to ‘OFF’ position and check cooling fan switches o󰀨 immediately.
LidSafetysystem(iftted)
Ignite all hotplate burners including wok. Attempt to close the lid and make sure all ames are
extinguished by the safety system.
If you are satised that the cooker is operating correctly, turn it o󰀨 and show the customer how to use it.
Make sure you ask the customer to operate the clock (if tted) and controls.
Explain to the user that the lid safety system must not be used as a means of turning o󰀨 the hotplate
burners. Control knobs must always be turned to the ‘OFF’ position after use.
Note: If the cooker does not perform correctly, inform the customer of the problem and put a warning
notice on the cooker. If the problem is dangerous, then disconnect the cooker. If there is a fault, then
the customer should be advised to contact the manufacturer’s local service organisation or the retailer
.
Before leaving the installation hand over the User Guide to the customer