Reversing the swing of the
door
# Remove the inner door glass by
lifting upwards.
# Undo the door stop securing screws
(2 off) and remove the door stops.
Note: A TORX head screwdriver
(size T10) is required for this opera-
tion.
# Undo the screws securing the upper
hinge and remove,
# Remove the door assembly from the
lower hinge. I nvert the upper
hinge so that it becomes the lower
hinge on the right hand side, fasten
to the front frame ensuring that the
bearing washer is fitted.
# Remove original door hinge and
insert into the top of the door
assembly. Offer up to the front
frame and insert both screws.
# Replace both door stops into their
new position at the bottom of the
door and insert the r etaining
screws.
# Refit the inner door glass.
# To enable the door to be used in
either l eft hand or right hand
opening mode, the appliance has
been fitted with a roller catch on
both sides of the front frame.
Moving the inner door glass
stop
# Undo the door stop securing screws
(2 off) and remove the door stops.
Note: A TORX head screwdriver
(size T10) is required for this opera-
tion.
# When the door is inverted, replace
the inner door stops and screws into
the holes on the opposite side of the
door extrusions.
30
Installation Instructions
To Next Page
Loading...
