Belling BI 60G - Page 32

INSTALLATION
Commissioning
Burner aeration
Allburnershavexedaerationandno
adjustment is possible.
Pressure setting
See technical data.
Electrical systems check
In the event of an electrical fault the
preliminary electrical system check (earth
continuity, short circuit, polarity and resis-
tance to earth) must be carried out.
Ignition check
Oven ignition:
Push in and turn the main oven control
knob anti clockwise to the ‘FULL ON’
position. The ignition system will spark
automatically. Push in the control knob to
ignite the gas. The sparking will stop. If
after 15 seconds, the burner has not lit,
turn off the oven and leave the compart-
ment door open. Wait at least one minute
before a further attempt to ignite the
burner.
Do not hold the control knob in for more
than 15 seconds.
Turn the control knob clockwise to the
requiredsetting.
To turn off, return the control knob to the
“off” position.
Grill ignition:
• The door must be open for grilling.
• Push in and turn the control knob
clockwise to the grill symbol. Before
leaving the installation
Show the customer how to ignite the oven
and operate the grill and give them this
handbook. Thank you.
Before leaving the installation
Show the customer how to ignite the oven
and operate the grill and give them this
handbook. Thank you.