Belling Hob - Basic Hob Function; Initial Power up; To Turn the Hob On;Off; Control Knob Safety Feature “O”

USING THE HOB - INDUCTION
BASIC HOB FUNCTION
Initial Power up (switching on the
electrical supply to the hob)
After connecting the hob to the mains
electrical supply, all segments of the
displaysareilluminated(lit)andabeep
sounds.
The hob then initialises after which, all
displaysaredeactivated(LEDsgoout)
and a beep sounds.
If there is an initialisation problem or if a
control knob is not set to the off position
all displays remain lit, until the initiali-
sation problem is solved or the control
knobs are turned to the off position.
To turn the hob ‘ON’ / ‘OFF’
To turn the hob ‘ON’, turn the control
knob for the required cook zone clockwise
to set the cook zone to the desired power
setting(1to9).Thepowerdisplaywill
automatically light up and will “beep”.
To turn the hob ‘OFF’ turn the control
knob anti-clockwise to the ‘OFF’ position.
When a cook zone is switched off, a beep
sounds and the corresponding display
shows the power level “0”. 10 seconds
after switching off, a beep sounds and the
corresponding display is switched off (As
Shownbelow)
Control Knob Safety Feature “o”
If at any time you see the “o” symbol,
it means that a control knob has been
left on and needs to be turned to the off
position(reset)beforethehobcanbe
used. This is to ensure that power isn’t
accidentally switched on to a cook zone
(i.e. turn the control knob off and back on
tocontinueusing).
Power Boost
Temporarily boost the power to a cook
zone by approx 25%. All zones can be
boosted for a period of up to 10 minutes.
When booster is selected, a beep sounds
and the corresponding display shows a
“P” symbol.
The booster function only works for a
limited period. After 10 minutes of boost
power level, the cook zone is automati-
cally deactivated, a beep sounds and the
corresponding display shows a “o”
symbol.
The corresponding control knob has to
beturnedbacktotheoffposition(reset)
before a new cook zone power level can
be set. (i.e. turn the control knob off and
backontocontinueusing).