How to fix communication error on Belling IH60R?
If you encounter a communication error on your Belling hob, turn the controls to the off position and then turn the power off and back on to reset the system.
How to fix induction generator over temperature on Belling IH60R Hob?
To resolve an induction generator over temperature issue on your Belling hob, check that the installation and free air flow to the hob are as per the installation instructions. Normal operation will resume when the appliance has cooled down.
Why does the fan keep running on my Belling IH60R Hob after I turn it off?
The fan in your Belling hob continues to run after it's turned off to cool down the electronics.
Why does my Belling IH60R make a clicking sound?
The slight clicking sound from your Belling hob is due to the distribution of power between two heating zones on the same side of the hob.
Why do my pans make noise on my Belling IH60R?
If your pans are making noise while cooking on the Belling hob, it's likely due to vibration from the energy transfer between the hob and the pan. This is normal for certain types of saucepans at high settings and won't damage the hob.
When does the 'H' disappear on my Belling hob?
The 'H' indicator on your Belling hob will switch off when the glass surface temperature drops below 55 degrees Celsius.
How to get rid of the smell from my new Belling IH60R Hob?
When first using your Belling hob, heat a pan full of water on each zone for half an hour to eliminate any smells.
How to solve induction generator relay error on Belling IH60R?
If you encounter an induction generator relay error on your Belling hob, turn the controls to the off position, then turn the power off and back on to reset the system.
How do I fix induction heater temperature sensor error on Belling hob?
If you encounter an induction heater temperature sensor (NTC) error on your Belling hob, turn the controls to the off position, then turn the power off and back on to reset the system.
What to do for induction heater over temperature on Belling hob?
If your Belling hob is showing an induction heater over temperature warning, which indicates an overheated pan, allow the hob to cool down. Normal operation should resume afterward.
Essential safety precautions and warnings for safe operation of the appliance.
Guidance on preventing kitchen fires and actions to take if a fire occurs.
Tips to prevent damage and procedures for appliance disposal.
Instructions for safe and effective operation of the hob surface.
Overview of induction technology, auto tuning, and basic controls.
Details on griddle zone, pan detection, cookware, and overheat protection.
Covers residual heat indicators, auto standby, and common troubleshooting.
Cleaning instructions for ceramic glass hob surfaces.
Cleaning and maintenance guidelines for solid plate hobs.
Essential general information and safety for installation.
Specifies minimum distances, clearances, and cabinet requirements.
Instructions for fitting the hob into the worktop and sealing.
Details on securing the hob and connecting to the power supply.
Specific power ratings for each cook zone.
Information on the web shop for accessories, spares, and cleaning products.
Contact details, model/serial number location, and service record section.
General| Type | Induction Hob |
|---|---|
| Width | 60 cm |
| Number of Zones | 4 |
| Total Power | 7.4 kW |
| Control Type | Touch Control |
| Boost Function | Yes |
| Child Lock | Yes |
| Residual Heat Indicator | Yes |
| Timer | Yes |
| Voltage | 220-240 V |
| Frequency | 50/60 Hz |
| Safety Features | Overheat Protection |
To Next Page
