What to do if my Belling IHL603 heating stops suddenly?
If your Belling Hob heating stops suddenly, it could be due to using the wrong type of pan. Ensure you are using the proper pan as described in the instruction manual. Alternatively, the hob may have overheated. In this case, wait for the temperature to return to normal and then push the “ON/OFF” button to restart the unit.
How to fix ceramic plate temperature sensor failure on Belling Hob?
To address a ceramic plate temperature sensor failure (open circuit) on your Belling hob, check the connection or replace the ceramic plate temperature sensor.
How to fix temperature sensor of the IGBT failure on Belling IHL603?
To address a temperature sensor of the IGBT failure (open circuit) in your Belling hob, replace the power board.
Why does the Cooking Mode Indicator come on but heating doesn't start on my Belling IHL603 Hob?
If the Cooking Mode Indicator on your Belling Hob comes on, but heating does not start, it could be due to several reasons. First, the hob may be too hot, so check the installation to ensure that the air inlets and outlets are not blocked. Second, there might be an issue with the fan. Verify that the fan runs smoothly; if it doesn't, replace it. Lastly, the power board might be damaged, requiring replacement.
What to do if the LED doesn't come on when my Belling Hob is plugged in?
If the LED on your Belling hob does not come on when the unit is plugged in, it could be due to a few reasons. First, ensure that the appliance is switched on at the fused spur cooker point on the wall, meaning that there is no power supplied. If the power supply is okay, the accessorial power board might be damaged, requiring replacement. Finally, the display board could also be damaged, and would need to be replaced.
Why do adjacent zones on my Belling Hob display “U”?
If adjacent zones on the same side of your Belling hob display “U ”, it could indicate a loose connection between the power board and the display board, so check the connection. It may also indicate a failure of the display board or the power board, requiring replacement.
What to do if the supply voltage is below the rated voltage on my Belling Hob?
If the supply voltage to your Belling hob is below the rated voltage, inspect whether the power supply is normal. Power on the hob after the power supply is normal.
What to do if there is high temperature of IGBT in my Belling IHL603 Hob?
If the temperature of the IGBT in your Belling hob is too high, wait for it to return to normal. Then, touch the “ON/OFF” button to restart the unit. Also, check whether the fan runs smoothly; if not, replace the fan.
What causes a communication error on my Belling Hob?
If there is a communication error with your Belling hob, reinsert the connection between the display board and the power board. If the issue persists, replace either the power board or the display board.
What to do if there is high temperature of ceramic plate sensor on my Belling IHL603?
If the temperature of the ceramic plate sensor on your Belling hob is too high, wait for the temperature to return to normal. Then, touch the “ON/OFF” button to restart the unit.
General| Type | Induction |
|---|---|
| Number of Zones | 4 |
| Total Power | 7.4kW |
| Control Type | Touch Control |
| Dimensions (W x D) | 590 x 520 mm |
| Cut-Out Dimensions (W x D) | 560 x 490 mm |
| Width | 590 mm |
| Weight | 10 kg |
| Voltage | 220-240 V |
| Frequency | 50/60 Hz |
| Material | Glass |
| Safety Features | Auto Shut-Off, Child Lock, Overheat Protection |
To Next Page
