What to do if my Belling IH60XL Hob won’t work and the indicators don’t come on?
If your Belling hob isn't working and the indicators are off, it could be due to an issue with the electricity supply. Check the fuses and the cut-out switch to ensure the appliance is receiving power. It may be a faulty supply or connection.
Why do my pans make a noise during cooking on my Belling IH60XL?
If your pans are making noise while cooking on your Belling hob, it's likely due to vibration from the energy transferring from the hob to the pan. This is normal for some types of saucepans at high settings and will not damage the hob.
What to do if Belling IH60XL Hob displays status code E8 - Fan blocked to appliance?
If your Belling hob displays status code 'E8', it indicates that the fan is blocked. To resolve this, ensure that the installation allows for free airflow and clean the fan inlets located at the rear or underside of the appliance.
What does Hob Status Code U400 mean on my Belling IH60XL?
If your Belling hob displays status code 'U400', it indicates a cable connection fault. You should check the mains cable connection and ensure the terminal at the terminal block are wired correctly.
What does Belling Hob Status Code ER21 mean?
If your Belling hob displays status code 'ER21' and cuts off after a programme setting, it means the appliance has overheated. Allow the hob to cool down.
What to do if my Belling Hob displays status code E2?
If your Belling hob displays status code 'E2', it indicates that the induction coil is overheating due to a hot pan. Remove the pans and allow the hob to cool down.
Why does my Belling Hob say 'No Power Boost'?
If your Belling hob displays 'No Power Boost', allow the appliance to cool down. The power boost function will become available once the appliance is cool.
Why does the fan keep working on my Belling IH60XL after it has been turned off?
The fan in your Belling hob continues to run after it's turned off to cool down the electronics.
Why does my Belling IH60XL make a slight clicking sound?
The slight clicking sound your Belling hob makes is due to the distribution of power between two heating zones on the same side of the hob.
How to get rid of the smell when using Belling IH60XL Hob for the first time?
When using your Belling hob for the first few times, if it produces a smell, heat a pan full of water on each zone for half an hour.
Important warnings and guidelines before operating the appliance.
Specific warnings related to the operation of induction hobs, including electrical safety.
Guidance on preventing fires, handling pan fires, and electrical fires.
Best practices for using the induction hob, including pan placement and handling hot surfaces.
Tips on preventing kitchen fires, especially unattended cooking and pan fires.
How to turn on the hob, select zones, adjust power, and control zones.
Steps to take if the hob and its indicators do not turn on.
Details and actions for error codes like L, ER21, U400, E2, E8.
Detailed measurements for safe installation clearances around the hob.
Steps for safely connecting the hob to the mains electricity supply.
To Next Page
General
