The unit panels next to the appliance must be heat resistant.
In the case of veneered wood units, glues must be resistant
to a temperature of 120°C.
Fitting Your Appliance
Fit the appliance into its surround (beneath a work-top or
above another appliance) by inserting screws into the 2
holes that can be seen in the frame of the oven when the
door is open.
Mounting Screws
Note:
Your appliance must be mounted on a flat surface for the full
width and depth of the product
Connect Power Supply Cord
◆ Pull open terminal board cover at rear panel of appliance.
◆ Fit wires through on terminal board and make connections
to terminals.
◆ Engage wires into plastic clip. Secure plastic clip with
supplied screws.
◆ Close the terminal board cover.
Hard Wired
Appliances :
When making the mains supply conductor connections to the terminal
block within the terminal box , please ensure that minimum clearances
are being maintained between individual conductors and conductors/
connectors to the adjacent metal surfaces of the terminal box itself ,
where possible add heat shrink sleeves to any bare conductor end/
connectors prior to securing.
Cabinet Construction For Your Appliance
The sizes of the unit for installing the ap
n a column unit are shown in figure.
To provide adequate ventilation, there must be
appropriate ventilation opening, the panel to which
the oven is fitted should have a gap of at least 70 mm
7
To Next Page
Loading...
