WARNING!
Please follow the points below when installing the
appliance
Use an Authorised Person
◆ Installation should be carried out according to the
instructions by a professionally qualified person.
The manufactcrer declines all responsibility for any
damage to persons, animals or things due to a
wrong installation.
◆ Wiring connections must be in accordance with
AS/NZS 3000 Wiring Rules and any particular
conditions of the local authority.
◆ Refer to data plate or rating information. The date
plate is positioned behind the bottom of the oven
door. The circuit diagram is positioned on the top
panel of the appliance.
◆ A functions switch should be provided near the
appliance in an accessible position. Refer to
AS/NZS
3000 clause 4.7.1
◆ Wiring should be protected against mechanical
failure. Refer to AS/NZS 3000 clause 1.5
◆ A means of disconnection with a contract
separation of at least 3mm must be supplied in the
fixed wiring. Always turn the grill off immediately
after use as fat left behind may catch fire.
◆ Unplug the power plug appliance from socket
before installation or any adjustment or
maintenance
This Appliance Must Be Properly Earthed
◆ Do not lift the appliance by the door handles.
◆ Prepare the cupboard opening to match your
appliance measurements (See Diagrams)
◆ Slide appliance into the cupboard, ensuring the
supply cable (where fitted) does not king.
◆ To prevent tipping, secure your oven into the
cupboard by fastening with 2 screws supplied.
◆ Where the appliance is built into a cabinet, the cabinet
must be capable of withstanding 120°C. Installation
into low temperature tolerant cabinetry
(eg Vinyl Coated) may result in deterioration of the low
temperature coating by discoloring or bubbling.
◆ The unit panels next to the appliance must be heat
resistant. In the case of veneered wood units, glue
must be resistant to a temperature of 120°C.
◆ If the appliance is to be installed adjacent to vinyl
wrapped surfaces, use an installation kit available
from the vinyl-wrap supplier.
◆ GSM cannot accept responsibility for damage caused
by installation into low temperature tolerant cabinets.
◆ After installation, test and ensure that the appliance
operates correctly before handing it over to the
customer.
◆ Once the appliance is installed, there must be no
possible contact with electrical parts. Any protective
parts must can only be removed with the use of tools
◆ If a power point is fitted, it must be accessible with the
appliance installed, as the plug must be accessible
after installation
◆ Always slide shelves into the layer with stopper
◆ Be cautious when using the oven, gloves may need to
be used
To avoid any potential hazard, you must follow our
instructions when you install your appliance. Failure
to install the appliance correctly could invalidate any
warranty or liability claims and lead to prosecution.
Install the Shelf
6
To Next Page
Loading...
