4. 1. 3 Power conditions
>> The electrical connection must be made in accordance with
the relevant regulations of the country in which it is used.
The voltage at the installation site must match the voltage
given on the nameplate.
WARNING: Danger of electric shock. Be sure to observe the
following points:
• It must be protected by a fuse with the amperage value stated
on the nameplate.
• All phases of the equipment must be able to be disconnected
from the power grid, and the lines connected to the power
line must be reliably grounded;
• Do not operate the machine with a damaged power cord.
Immediately replace damaged power cords or plugs by
professional technical service personnel;
• Bellucci recommends that you do not use extension cables!
If an extension cable must be used (minimum cross-section:
1.5 mm), please observe the manufacturer’s data (instruction
manual) for the power cord and local regulations;
• Install the power cord so that people cannot trip over it. Do
not let the power cord pass through sharp corners or hang in
the air, and do not pinch cables. In addition, the cables must
not be placed over high temperature objects and must be
protected from oils and aggressive cleaning agents;
• Do not lift or pull on the device by the power cord. Do not pull
the plug out of the socket by pulling on the power cord. Never
touch the power cord or plug with wet hands! Never insert
wet plugs into sockets!
!
15
To Next Page
Loading...
