Bellucci BISTRO - Page 35

Pressure overloaded
1. The pipe or strainer of Brewer is blocked;Coee Grounds from
Grinder are too fine; The amount Coee Grounds from Grinder
are over the max capacity of Brewer;Air is coming into the Pump
while coee making;
2. Tap “Rinse” to rinse Brewer;Adjust the gear position of the coee
machine to clockwise. The bigger number represents coarser.
Clean the Inlet of tank.
Grinder calibration
1. After a certain cups of coee made, it will alarm;lt will alarm at
the 2000th cup, 7000th cup, 1700th cup, 27000th cup ... and so
on. (every 10 thousand cups);
2. Follow the tips or contact the service center to finish calibration;
Follow the instruction of service manual.
Brewer check up
1. The Brewer is not in a right position; The Brewer damaged;
The drive motor of brewer damaged;
2. Tap “Check Up”; Replace a new Brewer; Replace new drive motor.
Brewer unit deep
clean required
1. Please follow instructions.
2. Follow the tips and enter service manual to do deep clean;
Follow the instructions of service manual.
Milk system deep
clean required
1. Reach the set value, it will alarm. Set in manual; The settled valve
can be changed in the service manual;
2. Follow the tips and enter service manual to do deep clean;
Follow the instructions of service manual.
Descaling required
1. Reach the set value, it will alarm. Set in manual; The settled valve
can be changed in the service manual;
2. Follow the tips and enter service manual to do the descaling;
Follow the instructions of service manual.
Water leakage
1. Water leaking inside the machine;
2. Disassemble the appearance of the machine and check the
specific leaking location; replace the accessories at the leaking
location.
No coee
1. The coee grounds are too fine;The amount coee grounds from
grinder are over the max capacity of brewer; The pipe or strainer
of Brewer is blocked;The Brewer damages; The Strainer of inlet
valve is blocked;
2. Adjust the gear position of the coee machine to clockwise. The
bigger number represents coarser;Do grounds calibration; Do
brewer deep rinse with tablets; Re-fix the Brewer, or replace a
new Brewer; Clean Strainer or replace a new one;
Brewer system error
1. Tap three times “brewer self-checking”, prompts brewer system
error; The brewer is blocked is stuck;The motor doesn’t work;
The brewer damages; Control Board damages;
2. Switch o the machine and restart; Disassemble the brewer,
check and clean; Replace a new motor; Replace a new Brewer;
Replace a new Control Board;
33