D2400 Homogenizer Manual Chapter 4 Operation Guide
─ 6 ─
1.3 Place tube retainer on top of the tube holder. Tighten the knob clockwise and push the
locking latch inwards. A click will indicate that the latch is in place. If the latch cannot be pushed
inwards, turn the knob 5 degrees and try again.
Note：The locking latch must be pushed in the “LOCK” position.
1.4 Close the cover and engage the cover latch. Operation can then begin.
DO NOT ATTEMPT TO OPERATE THE UNIT WITHOUT THE TUBE RETAINER IN PLACE!
Tighten the knob clockwise, and
push the locking latch inwards to
lock the tube retainer in place
To Next Page
Loading...
