Benchmark Scientific BeadBlaster 24 - Program Selection; Program Setting

D2400 Homogenizer Manual Chapter 4 Operation Guide
─ 7 ─
2. Program selection
50 onboard programs are available. To access the programs, press and hold the “Prog.” key, and
then use “” or “” keys to scroll through the programs. To change m/s to rpm, press “” and
“” key simultaneously.
3. Program setting
Step 1: Press “Set” key once, SPEED in display flashes, then press “” or “” to adjust the
speed.
Step 2: press “Set” key again, CYCLE in display flashes, then press “” or “” to set the number
of cycles.
Step 3: press “Set” key again, TIME in display flashes, then press “” or “” to set the run time.
Step 4: press “Set” key again, INTER in display flashes，then press “” or “” to set the pause
time.
Values will be automatically be saved after 3 seconds.
PROG：01 28ºC 
6.50 03
0:30 0:30
SPEED
M/S
M:S
TIME
CYCLE
INTER..
M:S