D2400 Homogenizer Manual Chapter 4 Operation Guide
─ 5 ─
Chapter 4 Operation Guide
1. Loading Tubes
1.1 Disengage the locking latch (as shown below), turn the knob counter-clockwise and remove
the tube retainer.
1.2 The tube holder may be filled in or out of the instrument. To remove, simply lift off the shaft.
Place sample tubes into the tube holder and press down until seated. If less than 24
samples are used, they should be evenly distributed in the tube holder. If removed, the tube
holder can then be replaced, making sure the two bumps on the holder line up with the
indentations on the shaft.
To Next Page
Loading...
