AHB2 Instruction Manual Rev F Page 13
Rack Mounting
The AHB2 is available in a rack-mount version. The AHB2 is magnetically shielded, and will not
interfere with sensitive equipment mounted above or below the AHB2.
Rack Mount Option
Rack Mounting Instructions
The AHB2 runs very cool when idle and runs very cool under most load conditions. However, it can
produce significant heat when heavily loaded. Make sure the rack is adequately ventilated. Make
sure the side heat sinks have an unobstructed air flow.
Some power amplifiers can emit very strong magnetic fields. These amplifiers should be kept at
least two rack units above or below the AHB2. Magnetic interference can produce hum problems.
If the AHB2 is mounted directly above another piece of equipment, it may be necessary to remove
the feet from the AHB2. Save the feet for future needs. Replacement feet may be purchased
directly from Benchmark or through most authorized Benchmark dealers.
To Next Page
Loading...
Need help?
General
