Bender rcm420 - Commissioning Procedure

Technical data
37
TGH1410en/03.2012
Utilization category...............................................................AC-13..........AC-14..........DC-12..........DC-12....... DC-12
Rated operational voltage ..................................................... 230 V ...........230 V .............24 V .......... 110 V ........ 220 V
Rated operational current..........................................................5 A...............3 A...............1 A........... 0.2 A......... 0.1 A
Minimum contact load..............................................................................................................1 mA at AC / DC ≥ 10 V
Environment/EMC
EMC .................................................................................................................................................................. IEC 62020
Operating temperature ......................................................................................................................... -25 ºC...+55 ºC
Classification of climatic conditions IEC 60721
Stationary use (IEC 60721-3-3) ........................................................3K5 (except condensation and formation of ice)
Transportation (IEC 60721-3-2) ........................................................2K3 (except condensation and formation of ice)
Storage (IEC 60721-3-1) ...................................................................1K4 (except condensation and formation of ice)
Classification of mechanical conditions acc. to IEC 60721:
Stationary use (IEC 60721-3-3) .............................................................................................................................. 3M4
Transportation (IEC 60721-3-2) .............................................................................................................................. 2M2
Storage (IEC 60721-3-1) ......................................................................................................................................... 1M3
Connection
Connection type.......................................................................................................... screw-type terminals
Connection properties:
rigid/ flexible/ conductor sizes .......................................................................... 0.2...4 / 0.2...2.5 mm
2
/ AWG 24...12
Multi-conductor connection (2 conductors with the same cross section):
rigid, flexible .............................................................................................................................0.2...1.5 / 0.2...1.5 mm
2
Stripping length ............................................................................................................................................... 8...9 mm
Tightening torque....................................................................................................................................... 0.5...0.6 Nm
Connection type............................................................................................................ push-wire terminals
Connection properties:
Rigid ............................................................................................................................... 0.2...2.5 mm
2
( AWG 24...14)
Flexible without ferrules................................................................................................. 0.2...2.5 mm
2
( AWG 24...14)
Flexible with ferrules ...................................................................................................... 0.2...1.5 mm
2
( AWG 24...16)
Stripping length .................................................................................................................................................. 10 mm
Opening force........................................................................................................................................................... 50 N
Test opening, diameter....................................................................................................................................... 2.1 mm
Other
Operating mode ........................................................................................................................... continuous operation