LR-10000 Low-Rise Scissor Lift 32 P/N 5900075 — Rev. B — August 2021
If any of the Lift Pads are
not
making solid contact with the Lifting Points, lower the Lift and adjust
the Lift Pads so that they make better contact.
12. Rock the Vehicle to make sure the Vehicle is stable and balanced.
If the Vehicle is
not
stable and balanced, lower the Lift back to the ground and start over.
If the Vehicle
is
stable and balanced, it is safe to raise further.
⚠ DANGER Do not raise the Lift further until you are certain the Vehicle on the Lift is both stable
and balanced. If the Vehicle is
not
stable and balanced, it could fall, which could
damage the Vehicle, damage the Lift, or injure or kill anyone under the Vehicle.
13. On the Power Unit, press and hold the Raise button.
14. Watch the Vehicle and the Platforms as they rise.
If the Lift becomes unstable or the Vehicle starts moving, release the Raise button immediately.
15. When the Platforms are just past the desired height, release the Raise button.
16. Press the Lowering Handle to move the Platforms back down, which engages them on the most
recently passed Safety Lock.
If you miss the Safety Lock, press and hold Raise again and go somewhat further past the Safety
Lock, then hold the Lowering Handle again to engage the Lift on the Safety Lock.
Lowering a Vehicle
This section describes how to lower a Vehicle from a raised position.
To lower a Vehicle:
1. Check the items listed in Lift Operation Safety.
If you find any issues, resolve them before lowering the Vehicle.
Only use the Lift if it can be used safely
.
2. Press and hold the Raise button for a second or two, to move the Platforms off the Safety Lock.
3. Move the Safety Lock Release Handle to the Raised position.
This pushes the Safety Lock Bar up, allowing the Safety Locks to be passed by.
4. Press and hold the Lowering Handle.
5. Release the Lowering Handle when the Lift is fully lowered.
6. Move the Safety Lock Release Handle back to the Lowered position.
7. Carefully drive the Vehicle off.
To Next Page
Loading...
