EasyManua.ls Logo

BendPak LR-10000 - Maintenance

Default Icon
44 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
LR-10000 Low-Rise Scissor Lift 33 P/N 5900075Rev. B August 2021
Maintenance
DANGER Before performing any maintenance, make sure the Lift is completely disconnected
from power and
cannot
be re-energized until all maintenance is complete.
BendPak strongly recommends using your Power Disconnect Switch during
maintenance. If your organization has Lockout/Tagout policies, make sure to
implement them during all maintenance.
To maintain your Lift:
Daily: Keep the Lift clean. Wipe up any oil spills, clean any dirt.
Daily: Make a visual inspection of all moving parts and check for damage or excessive wear. If
you find any damaged or worn parts, take the Lift out of service until they are replaced.
DANGER If a Vehicle is raised when you notice the damage or extreme wear, very carefully
lower the Vehicle to the ground. When the Lift is on the ground, take it out of
service, disconnect it from power, and make arrangements to fix the damage or
wear. Service and maintain the unit only with factory-approved replacement parts.
Daily: Make sure the Safety Locks are in good operating condition. If you find that the Safety
Locks are damaged or excessively worn, take the Lift out of service until they are replaced.
Do
not use your Lift if the Safety Locks are damaged or excessively worn
.
Weekly: Check all controls to make sure they are functioning normally.
Weekly: Check all labels on the unit. Replace them if they are illegible or missing.
Monthly: Lubricate the grease fittings. We recommend using white lithium grease or similar.
Monthly: Check the Power Unit’s Hydraulic Fluid levels. Refill if low.
Every two months: Check all Anchor Bolts to make sure they are tight. If not, tighten them.
WARNING Do not operate your Lift if you find issues; instead, take the Lift out of service, then
contact your dealer, email support@bendpak.com, visit
bendpak.com/support, or call (800) 253-2363, extension 196.
Lubrication
The following drawing shows the lubrication points for the Lift. Note that some lubrication points are
under other parts of the Lift.

Other manuals for BendPak LR-10000

Related product manuals