BendPak LR-10000 - Page 5

LR-10000 Low-Rise Scissor Lift 5 P/N 5900075 — Rev. B — August 2021
• Do not operate equipment with a damaged power cord or if the equipment has been dropped or
damaged – until it has been examined by a qualified service person.
• Do not let a cord hang over the edge of a table, bench, or counter or come in contact with hot
manifolds or moving fan blades.
• If an extension cord is necessary, a cord with a current rating equal to or more than that of the
equipment should be used. Cords rated for less current than the equipment may overheat. Care
should be taken to arrange the cord so that it will not be tripped over or pulled.
• Always unplug equipment from the electrical outlet when not in use. Never use the cord to pull the
cord from the outlet. Grasp plug and pull to disconnect.
• Let equipment cool completely before storing away. Loop cord loosely around the equipment
when storing.
• To reduce the risk of fire, do not operate the equipment in the vicinity of open containers of
flammable liquids (gasoline).
• To reduce the risk of fire or electric shock, never overload receptacles. Refer to the labels for the
proper load on receptacles.
• To reduce the risk of electric shock, do not use on wet surfaces or expose to rain.
• Adequate ventilation should be provided when working on operating internal combustion engines.
• Consider the work environment. Keep the work area clean. Cluttered work areas invite injuries.
Keep areas well lit.
• Always make sure the Safety Locks are engaged before attempting to work on or near a Vehicle.
• Make a visual inspection of the product
before using it. Check for damage or missing parts. Do
not use the product if you find any issues. Instead, take it out of service, then contact your dealer,
email support@bendpak.com, visit bendpak.com/support, or call (800) 253-2363.
• Make a thorough inspection of the product at least once a year. Replace any damaged or severely
worn parts, decals, or warning labels.
• BendPak recommends referring to the ANSI/ALI ALIS Standard (R2015) Safety Requirements for
Installation and Service for more information about safely installing, using, and servicing your Lift.
Symbols
Following are the symbols used in this manual:
⚠ DANGER Calls attention to an immediate hazard that will result in injury or death.
⚠ WARNING Calls attention to a hazard or unsafe practice that could result in injury or death.
⚠ CAUTION Calls attention to a hazard or unsafe practice that could result in minor personal
injury, product, or property damage.
NOTICE Calls attention to a situation that, if not avoided, could result in product or property
damage.
Tip Calls attention to information that can help you use your product better.