RBJ Series of Rolling Bridge Jacks 11 P/N 5900004 — June 2018 — Rev. C2
• The Lift must be lowered. Before situating your Rolling Bridge Jack, fully lower the Lift or set it
on its lowest Safety Lock position.
Tip If you are going to be using a crane to situate your Rolling Bridge Jack, you may need to
lock the Lift on the lowest Safety Lock position to make room for the legs of the crane.
• You can only use the Rolling Bridge Jack in certain locations on the Lift. This is
because the strength of the Lift is less in the middle, so raising a vehicle in the middle could
permanently damage the Lift’s Runways. In the vast majority of cases, this unusable area in the
middle of the Lift will not impact your use of your Rolling Bridge Jacks, as the length of the
wheelbases of the Vehicles you are raising will put the Rolling Bridge Jacks in the usable area.
⚠ CAUTION Using Rolling Bridge Jacks in the middle of the Lift could permanently damage the
Lift’s runways.
Damage caused by this unsupported use of Rolling
Bridge Jacks is not covered by the warranty.
Drawing not necessarily to scale. Not all components shown.
To Next Page
Loading...
Need help?
General
