RBJ Series of Rolling Bridge Jacks 10 P/N 5900004 — June 2018 — Rev. C2
This reduced capacity based on vehicle wheelbase does not impact the rated capacity of the Rolling
Bridge Jacks used on those Lifts. Nevertheless, make sure to always check the rated capacity of the
Lift your Rolling Bridge Jacks are being used on to make sure it does not exceed the rated capacity of
the Lift.
Setup
This section describes how to set up your Rolling Bridge Jack.
Safety Rules
When installing a Rolling Bridge Jack, your safety depends on proper training and thoughtful operation.
⚠ WARNING Do not install this equipment unless you have automotive lift installation training.
Always use proper lifting tools, such as a forklift or shop crane, to lift heavy
components. Do not install this equipment without reading and understanding this
manual and the safety labels on the unit.
Only fully trained personnel should be involved in installing this equipment. Pay attention at all times.
Use appropriate tools and lifting equipment. Stay clear of moving parts.
⚠ WARNING You must wear appropriate protective equipment during setup: leather gloves,
steel-toed work boots, eye protection, back belts, and hearing protection.
Tools
You may need some or all of the following tools:
• Hex key wrench set
• Medium crescent wrench
• Forklift, shop crane, or other heavy lifting device
• Medium flat screwdriver
• Tape measure, 25 feet or longer
• Air fitting, to connect the Air-Operated Hydraulic Pump to air pressure
Preparing the Lift
Rolling Bridge Jacks go into the open space between the two runways of the four-post Lift.
Keep the following in mind:
• The Lift must be installed properly and operating normally. Only use a Rolling Bridge
Jack with a Lift that has been installed according to the manufacturer’s instructions and is
operating normally per those instructions.
⚠ WARNING Do not set up or use a Rolling Bridge Jack if the Lift is not the model the Rolling
Bridge Jack was designed for or the Lift was improperly installed. Instead, contact
the manufacturer of the Lift or BendPak Customer Service at (800) 253-2363 for
instructions.
To Next Page
Loading...
Need help?
General
