RBJ Series of Rolling Bridge Jacks 5 P/N 5900004 — June 2018 — Rev. C2
• Make sure all operators read and understand this Installation and Operation Manual. Keep the
manual near the device at all times.
• Make a visual inspection of the product before using it every time. Check for missing or damaged
parts. Do not use the product if you find any of these issues. Instead, take the Jack out of service,
then contact an authorized repair facility, your distributor, or BendPak at (800) 253-2363.
• Make a thorough inspection of the product at least once a year. Replace any damaged or severely
worn cables, hydraulic hoses, decals, or warning labels. Do not use the product until worn or
damaged items have been replaced.
• Do not touch hot parts; you could be burned.
• Take care locating cables and hoses; you do not want them driven over or stepped on.
• Always wear steel-toed footwear and safety glasses when using the Jack.
• Clear the area immediately if a vehicle is in danger of falling off the Rolling Bridge Jack.
•
Make sure the Rolling Bridge Jack is on a Safety Lock before starting work.
• Operating temperature for a Rolling Bridge Jack is 41°F to 104°F (5°C to 40°C).
• Make sure the weight of a vehicle being raised by a Rolling Bridge Jack does not exceed its
maximum lifting capacity.
Symbols
Following are the symbols used in this manual:
⚠ DANGER Calls attention to an immediate hazard that
will
result in death or severe injury.
⚠ WARNING Calls attention to a hazard or unsafe practice that
could
result in death or severe
personal injury.
⚠ CAUTION Calls attention to a hazard or unsafe practice that could result in minor personal
injury, product, or property damage.
NOTICE Calls attention to a situation that, if not avoided, could result in product or property
damage.
Liability Information
BendPak assumes no liability for damages resulting from:
• Use of the equipment for purposes other than those described in this manual.
• Modifications to the equipment without prior, written permission from BendPak.
• Damage to the equipment from external influences.
• Incorrect operation of the equipment.
To Next Page
Loading...
Need help?
General
