BendPak SP-7XE - Page 33

SP-7XE/F Full-Rise Scissor Lift 33 P/N 5900010 — Rev. B3 — September 2023
To Anchor the Console:
1. Remove the Front Console Weldment and the four M6 Hex Head Bolts that hold it in place; this
allows access to the inside of the Console to insert the Anchors.
Keep the components nearby, you will need them again soon.
2. Locate the mounting holes on the bottom of the Left and Right Console Weldments (on the inside).
The Anchor Bolts go into these holes.
Important: BendPak recommends marking the holes with the Drill through the Console Base,
then moving the Base out of the way to finish drilling the holes to the 3 in. depth.
3. Using the holes in the Console Base as a guide, drill the holes Ø3/8 in. diameter by 3 in. deep into
the Concrete.
Go in straight; do not let the drill wobble. Use a carbide bit for concrete applications (conforming to
ANSI B212.15).
⚠ WARNING Always wear the appropriate eye protection and protective equipment.
4. Remove all dust and debris from the holes.
Use a wire brush, vacuum, hand pump, or compressed air. Do not ream the hole. Do not make
the hole any wider than the drill bit made it.
5. Move the Console back over the drilled holes.
6. Retrieve the four Anchor Bolts from the Parts Bag, make sure the Washer and Nut are in place,
then insert the anchor Bolt into the mounting hole in the Console and through the drilled hole in the
Concrete.
7. Hammer or mallet the Wedge Anchor the rest of the way down into the hole.
Stop hammering when the Washer is snug against the Console Base.
8. Wrench the Nut clockwise to the recommended installation torque, 10-15 ft. lbs., using a Torque
Wrench.
⚠ CAUTION Do not use an impact wrench to torque the Anchor Bolts.