SP-7XE/F Full-Rise Scissor Lift 36 P/N 5900010 — Rev. B3 — September 2023
About Thread Sealants
Liquid Thread Sealant lubricates and fills the gaps
between the Fitting threads and leaves no residue that
could contaminate the Hydraulic Fluid.
Other types of Thread Sealants (like Teflon Tape) can
shred during installation or removal and eventually enter
the Hydraulic System.
Thread Sealant can be used with most Hydraulic Fittings,
although you only need to use
it with NPT connectors.
Apply the thread sealant when the ambient temperature is
between +46.5°F to +70°F (+8°C to 21°C)
To apply Thread Sealant:
1. Make sure the Fittings and connectors you are going to use are clean and dry.
If you are adding Thread Sealant to a Fitting or connector that has already been used with a
different sealant, use a wire brush to thoroughly remove the old sealant before adding more.
2. Skipping the first thread, apply a small amount of Thread Sealant to the next four threads of the
Fitting.
⚠ WARNING Always wear the proper protective equipment when handling Thread Sealant.
You only need a small amount because the sealant spreads to the other threads as it is tightened
into place.
If you put too much, the excess liquid will be pushed out when the Fitting is tightened; use a rag to
wipe the excess.
3. Tighten the Fitting into the connector; do not over tighten the Fitting.
4. Allow the 24-hour manufacturer-recommended curing time before pressurizing the system.
To Next Page
Loading...
