SP-7XE/F Full-Rise Scissor Lift 37 P/N 5900010 — Rev. B3 — September 2023
Connect the Hydraulic Hoses
The SP-7XE Lifts come with two Hydraulic Hoses, both of which are routed from one of the
two Hydraulic Power Ports on the Power Unit to one of the Hydraulic Cylinders. The two Hydraulic
Hoses are the same length, so it does not matter which Lift Frame they attach to.
Note: Hydraulic Hoses and Fittings are different from Compression Lines and Fittings. This section
covers Hydraulic Hoses and Fittings only.
The following illustration shows how to route the Hydraulic Hoses from the Console to the Hydraulic
Cylinders.
The following illustration shows a detail of the connections to the Hydraulic Cylinders.
To Next Page
Loading...
