BendPak XP-10C User Manual

INSTALLATION AND OPERATION MANUAL
SSHHIIPPPPIINNGG DDAAMMAAGGEE CCLLAAIIMMSS
When this equipment is shipped, title passes to the
purchaser upon receipt from the carrier. Consequently,
claims for the material damaged in shipment must be made
by the purchaser against the transportation company at the
time shipment is received.
BBEE SSAAFFEE
Your new lift was designed and built with safety in
mind. However, your overall safety can be increased
by proper training and thoughtful operation on the part
of the operator. DO NOT operate or repair this equip-
ment without reading this manual and the important
safety instructions shown inside.
1645 Lemonwood Dr.
Santa Paula, CA. 93060, USA
Toll Free 1-800-253-2363
Tel: 1-805-933-9970
Fax: 1-805-933-9160
Keep this operation manual near the
machine at all times. Make sure that
ALL
USERS read this manual .
10,000 POUND CAPACITY
12,000 POUND CAPACITY
15,000 POUND CAPACITY
18,000 POUND CAPACITY
SURFACE MOUNTED
TWO-POST LIFTS
MODELS:
XP-10C
XP-10CX
XP-10AC
XP-10ACX
XP-12CTA
XP-15C
XP-18C
PLEASE READ THE ENTIRE CONTENTS OF THIS MANUAL PRIOR TO
INSTALLATION AND OPERATION. BY PROCEEDING YOU AGREE THAT YOU
FULLY UNDERSTAND AND COMPREHEND THE FULL CONTENTS OF THIS
MANUAL. FORWARD THIS MANUAL TO ALL OPERATORS. FAILURE TO
OPERATE THIS EQUIPMENT AS DIRECTED MAY CAUSE INJURY OR DEATH.
REV B 10-24-07

BendPak XP-10C Specifications

General

Brand	BendPak
Model	XP-10C
Category	Lifting Systems
Language	English

Summary

INSTALLATION AND OPERATION MANUAL

READ FIRST

SAFETY AND RESPONSIBILITIES

DEFINITIONS OF HAZARD LEVELS

Explanation of hazard symbols (DANGER, WARNING, CAUTION) and their meanings.

INSTALLATION PROCEDURE

SELECTING SITE

Guidelines for choosing a suitable location, considering space and obstructions.

INSTALLING SAFETIES AND SAFETY CABLE

Steps for installing safety weldments, clevis pins, and torsion springs.

LIFT START UP / FINAL ADJUSTMENTS

Checks and adjustments for safeties, locks, and cable tension after installation.

OPERATION AND MAINTENANCE

TO RAISE LIFT

Instructions for safely loading and raising a vehicle onto the lift.

TO LOWER LIFT

Procedure for safely lowering a vehicle and disengaging safety locks.

TROUBLESHOOTING

LIFT WILL NOT RAISE

Common causes and remedies when the lift fails to raise.

MOTOR WILL NOT RUN