BendPak XP Series User Manual

Forward this manual to all operators.
Failure to operate this equipment as
directed may cause injury.
Revised 10-06-06
INSTALLATION AND OPERATION MANUAL
SSHHIIPPPPIINNGG DDAAMMAAGGEE CCLLAAIIMMSS
When this equipment is shipped, title passes to the
purchaser upon receipt from the carrier. Consequently,
claims for the material damaged in shipment must be made
by the purchaser against the transportation company at the
time shipment is received.
BBEE SSAAFFEE
Your new lift was designed and built with safety in
mind. However, your overall safety can be increased
by proper training and thoughtful operation on the part
of the operator. DO NOT operate or repair this equip-
ment without reading this manual and the important
safety instructions shown inside.
1645 Lemonwood Dr.
Santa Paula, CA. 93060, USA
Toll Free 1-800-253-2363
Tel: 1-805-933-9970
Fax: 1-805-933-9160
Keep this operation manual near the
machine at all times. Make sure that
ALL
USERS read this manual .
SURFACE MOUNTED
TWO-POST LIFTS
MODELS:
XP-10C
XP-10CX
XP-10AC
XP-10ACX
XP-12CTA
XP-12FTA
XP-15C
XP-18C

BendPak XP Series Specifications

General

Brand	BendPak
Model	XP Series
Category	Lifting Systems
Language	English

Summary

Warranty

Parts Inventory

Hose & Cable Chart

Introduction

Important Safety Instructions

Tools Required

Installation Guide

Step One: Site Selection

Guidance on choosing the correct location for lift installation.

Step Two: Floor Requirements

Specifications for concrete base and floor suitability.

Step Three: Site Layout

Procedures for marking and preparing the installation site grid.

Step Four: Installing Power Side Column

Detailed steps for mounting the main power side column.

Step Five: Mounting Offside Column

Procedures for positioning and securing the offside column.

Step Six: Mounting Overhead Beam

Instructions for attaching the overhead beam between columns.

Step Seven: Mounting Power Unit

Attaching and connecting the hydraulic power unit.

Step Eight: Installing Safeties and Safety Cable

Procedures for installing safety mechanisms and cables.

Step Nine: Installing Hydraulic Lines

Connecting hydraulic hoses and fittings to the lift cylinders.

Step Ten: Routing Equalizer Cables

Proper routing of equalizer cables for balanced lifting.

Step Eleven: Installing Overhead Micro Switch

Mounting and connecting the overhead micro switch.

Step Twelve: Power Unit Installation and Start-Up

Initial power unit installation, checks, and start-up procedures.

Step Thirteen: Installing Safety Cover

Attaching protective covers to the safety components.

Important Leveling Instructions

Lubrication

Start-Up and Bleeding

Operation Procedures

To Raise Lift

Step-by-step guide for safely lifting a vehicle.

To Lower Lift

Step-by-step guide for safely lowering a vehicle.

Maintenance

Required Monthly Maintenance

Schedule and tasks for regular lift maintenance.

Utility Air-Electric Workstation

Safe Lift Operation

Training Requirements

Essential training topics for lift operators.

Lift Operation Safety

Critical safety practices during vehicle lifting operations.

Troubleshooting

Lift Will Not Raise

Identifies causes and remedies for lift failure to raise.

Motor Will Not Run

Addresses issues related to the lift motor not operating.

Lift Lowers Slowly or Not At All

Diagnoses and resolves issues with slow or non-existent lowering.

Will Not Raise Loaded Lift

Solutions for when the lift cannot lift a vehicle.

Lift Will Not Stay Up

Addresses problems with the lift failing to maintain its elevated position.