BendPak XpR-10ACX User Manual

1
INSTALLATION AND OPERATION MANUAL
SHIPPING DAMAGE CLAIMS
When this equipment is shipped, title passes to the
purchaser upon receipt from the carrier. Consequently,
claims for the material damaged in shipment must be made
by the purchaser against the transportation company at the
time shipment is received.
BE SAFE
Your new lift was designed and built with safety in mind.
However, your overall safety can be increased by proper
training and thoughtful operation on the part of the operator.
DO NOT operate or repair this equipment without reading
this manual and the important safety instructions shown
inside.
1645 Lemonwood Dr.
Santa Paula, CA. 93060, USA
Toll Free 1-800-253-2363
Tel: 1-805-933-9970
Fax: 1-805-933-9160
wwwbendpak.com
Keep this operation manual near the
machine at all times. Make sure that
ALL USERS read this manual.
10,000 POUND CAPACITY
12,000 POUND CAPACITY
15,000 POUND CAPACITY
18,000 POUND CAPACITY
SURFACE MOUNTED
TWO-POST LIFTS
MODELS:
XPR-10C
XPR-10CX
XPR-10AC
XPR-10ACX
XPR-12C
XPR-15C
XPR-18C
VERSION A
PLEASE READ THE ENTIRE CONTENTS OF THIS MANUAL PRIOR TO
INSTALLATION AND OPERATION. BY PROCEEDING YOU AGREE THAT
YOU FULLY UNDERSTAND AND COMPREHEND THE FULL CONTENTS OF
THIS MANUAL. FORWARD THIS MANUAL TO ALL OPERATORS. FAILURE TO
OPERATE THIS EQUIPMENT AS DIRECTED MAY CAUSE INJURY OR DEATH.
MAN REV F 02-08-11
pn# 5900043
Pulley Pins. top and bottom
Arm Restraint Gears now Adjustable
Foot Guards on Column Base Bolt on
Top Trough Conguration
Lift Head Reinforcing Plates (Washers)
Micro Switch Cover Plate
Arm resistants left and right

BendPak XpR-10ACX Specifications

General

Lifting Capacity	10, 000 lbs
Motor	2 HP
Time to Full Rise	45 seconds
Minimum Height	4.5 inches
Overall Width	132 inches
Outside Columns	120 inches
Front Reach	48 inches
Rear Reach	48 inches
Drive-Thru Clearance	96 inches
Floor to Overhead Switch	141" / 3, 581 mm

Summary

Introduction and Safety

Read First

Crucial safety instructions before installation and operation.

Pre-Operation and Final Checks

Lift Operation

Operator Responsibilities

Defines employer duties for operator training, lift inspection, and maintenance.

Safe Operation Principles

Key principles for safe operation, including inspections, load limits, and area clearance.

Raising and Lowering Procedures

Procedures for safely raising, loading, and lowering vehicles onto the lift.

Maintenance and Troubleshooting

Maintenance Instructions

Daily, weekly, and monthly maintenance tasks for lift upkeep.

Troubleshooting Guide

Diagnosing and resolving common lift problems such as 'Will Not Raise' or 'Motor Not Running'.