BendPak XPR-10 Series - User Manual

1645 Lemonwood Dr.
Santa Paula, CA 93060 USA
Toll Free: (800) 253-2363
Tel: (805) 933-9970
bendpak.com
XPR-10 Series Two-Post Lifts
Installation and Operation Manual
Manual P/N 5900951 — Manual Revision D — May 2019
Models:
• XPR-10S
• XPR-10AS
• XPR-10XLS
• XPR-10AXLS
Model XPR-10S shown.
Designed and engineered by BendPak Inc. in Southern California, USA. Made in China.
⚠ DANGER
Read the entire contents of this manual before using this
product. Failure to follow the instructions and safety precautions in
this manual can result in serious injury or death. Make sure all other
operators also read this manual. Keep the manual near the product
for future reference. By proceeding with setup and operation, you
agree that you fully understand the contents of this manual.

BendPak XPR-10 Series Specifications

General

Capacity	10, 000 lbs
Rise Time	45 seconds
Voltage	220V
Motor	2 HP
Minimum Height	4.5 inches
Overall Height	145" / 3, 683 mm

Summary

Safety Guidelines and Precautions

General Safety Rules

Essential safety rules to follow before, during, and after lift operation.

Symbols and Warnings

Identification of Lift Components

XPR-10 Series Lift Specifications

Model-Specific Technical Data

Pre-Installation Checklist

Lift Installation Procedures

Installation Checklist and Preparation

Installing Posts and Cables

Hydraulic Lines and Power Unit Mounting

Safety Systems and Final Connections

Installing safety assemblies, covers, and making final electrical connections.

Operating the Automotive Lift

Lift Operation Safety Rules

Critical safety rules for operating the lift, including checks and operator responsibilities.

Lifting Points and Adapters

Raising and Lowering Vehicles

Step-by-step instructions for safely raising and lowering vehicles using the lift.

Safety Locks Operation

Lift Maintenance Schedule

Routine Maintenance Checks

Troubleshooting Common Lift Issues

Common Problems and Solutions

Table listing common lift issues and recommended actions to resolve them.

Wiring Diagrams for Microswitches

XPR-10 Series Parts Drawings