BendPak XpR-10CX - User Manual

1
INSTALLATION AND OPERATION MANUAL
SHIPPING DAMAGE CLAIMS
When this equipment is shipped, title passes to the
purchaser upon receipt from the carrier. Consequently,
claims for the material damaged in shipment must be made
by the purchaser against the transportation company at the
time shipment is received.
BE SAFE
Your new lift was designed and built with safety in mind.
However, your overall safety can be increased by proper
training and thoughtful operation on the part of the operator.
DO NOT operate or repair this equipment without reading
this manual and the important safety instructions shown
inside.
1645 Lemonwood Dr.
Santa Paula, CA. 93060, USA
Toll Free 1-800-253-2363
Tel: 1-805-933-9970
Fax: 1-805-933-9160
wwwbendpak.com
Keep this operation manual near the
machine at all times. Make sure that
ALL USERS read this manual.
10,000 POUND CAPACITY
12,000 POUND CAPACITY
15,000 POUND CAPACITY
18,000 POUND CAPACITY
SURFACE MOUNTED
TWO-POST LIFTS
MODELS:
XPR-10C
XPR-10CX
XPR-10AC
XPR-10ACX
XPR-12C
XPR-15C
XPR-18C
VERSION A
PLEASE READ THE ENTIRE CONTENTS OF THIS MANUAL PRIOR TO
INSTALLATION AND OPERATION. BY PROCEEDING YOU AGREE THAT
YOU FULLY UNDERSTAND AND COMPREHEND THE FULL CONTENTS OF
THIS MANUAL. FORWARD THIS MANUAL TO ALL OPERATORS. FAILURE TO
OPERATE THIS EQUIPMENT AS DIRECTED MAY CAUSE INJURY OR DEATH.
MAN REV F 02-08-11
pn# 5900043
Pulley Pins. top and bottom
Arm Restraint Gears now Adjustable
Foot Guards on Column Base Bolt on
Top Trough Conguration
Lift Head Reinforcing Plates (Washers)
Micro Switch Cover Plate
Arm resistants left and right

BendPak XpR-10CX Specifications

General

Brand	BendPak
Model	XpR-10CX
Category	Lifting Systems
Language	English

Summary

Introduction, Warranty, and Safety Basics

Manual Overview and Safety Warnings

Key safety warnings, cautions, and operational notices for safe use.

Product Warranty and Owner Responsibilities

Lift warranty details, owner's duties, and hazard definitions.

Installation Preparation and Procedures

Tools, Site, and Floor Requirements

Tools needed, site selection criteria, and floor specifications for installation.

Column and Structure Assembly

Steps for preparing columns, laying out the site, and assembling the lift structure.

Power Unit and Safety Systems Installation

Mounting the hydraulic power unit and installing safety features and hydraulic lines.

Final Checks, Operation, and Maintenance

Lift Leveling, Arm Installation, and Startup

Procedures for lift leveling, arm installation, startup, and final checks.

Safe Operation and Maintenance Guidelines

Guidelines for safe operation, daily checks, and maintenance schedules.

Wire Rope Care and Safety Label Management

Wire rope inspection, lubrication, and safety label placement instructions.

Troubleshooting and Documentation

Common Lift Issues and Solutions

Troubleshooting guides for lift not raising, motor issues, or stability problems.

Installation Forms and Maintenance Records

Forms for recording installation details and maintenance logs.