XPR-10 Series Two-Post Lifts 30 P/N 5900951 ā Rev. D ā May 2019
Putting in Chalk Line Guides
Based on the Specifications for your Lift, create Chalk Line Guides on the ground for the two Posts
prior to moving them into position.
Use the Width Overall value in Specifications
for your Lift model
to determine where to place
the Chalk Line Guides. The Width Overall value is defined as the distance from the back of one base
plate to the back of the other base plate.
Make sure to choose the Width Overall value for the Narrow or Wide orientation, based on the
selection you made earlier.
The following drawing shows how to create Chalk Line Guides for an
Asymmetric
Lift.
Not necessarily to scale. Not all components shown.
To Next Page
Loading...
