XPR-10 Series Two-Post Lifts 44 P/N 5900951 ā Rev. D ā May 2019
Installing the Safety Assemblies and the Safety Lock Cable
Your XPR-10 Lift has two Safety Assemblies: one on the Powerside Post (above the Power Unit) and
the other on the Offside Post.
The two Safety Assemblies take the Lift off of its Safety Locks so the Lift Arms can be lowered. The
Safety Assemblies need to be disengaged at the same time so that the Lift Arms lower together. In
order to do this, the two Safety Assemblies are connected to each other via the Safety Lock Cable,
which is routed through the Overhead Assembly.
Routing the Safety Lock Cable was done earlier; refer to Routing the Safety Lock Cable for
additional information.
The Safety Assembly on the Powerside Post includes a handle, which is used to lower the Lift off of its
Safety Locks (in conjunction with the Lowering Handle).
Not necessarily to scale. Not all components shown.
To Next Page
Loading...
