STEP ONE
( Selecting Site )
Before installing your new lift, check the
following.
1. LIFT LOCATION: Always use architects plans
when available. Check layout dimension against
floorplan requirements making sure that
adequate space is available.
2. OVERHEAD OBSTRUCTIONS: The area
where the lift will be located should be free of
overhead obstructions such as heaters, building
supports, electrical lines etc.
3. DEFECTIVE CONCRETE: Visually inspect
the site where the lift is to be installed and check
for cracked or defective concrete.
STEP TWO
( Floor Requirements )
Specifications of concrete must be adhered to.
Failure to do so could cause lift failure resulting
in personal injury or death.
A level floor is suggested for proper installation.
Small differences in floor slopes may be
compensated for by proper shimming.
If a floor is of questionable slope, consider a
survey of the site and/or the possibility of
pouring a new level concrete slab.
DO NOT install this lift on any asphalt
surface or any surface other than concrete.
DO NOT install this lift on expansion
seams or on cracked or defective concrete.
DO NOT install this lift on a second /
elevated floor without first consulting building
architect.
DO NOT install this lift outdoors unless
special consideration has been made to
protect the power unit from inclimate weather
conditions.
CONCRETE SPECIFICATIONS
LIFT CONCRETE
MODEL REQUIREMENT
7,000 Lb. Models 4” Min. Thickness / 3000 PSI
10,000 Lb. Models 4” Min. Thickness / 3000 PSI
12,000 Lb. Models 6” Min. Thickness / 3000 PSI
15,000 Lb. Models 6” Min. Thickness / 3000 PSI
18,000 Lb. Models 8” Min. Thickness / 3000 PSI
TOOLS REQUIRED
Rotary Hammer Drill Or Similar
3/4" Masonry Bit
Hammer
4 Foot Level
Open-End Wrench Set: 7/16" - 1-1/8"
Socket And Ratchet Set: 7/16" - 1-1/8"
Hex-Key / Allen Wrench Set
Medium Crescent Wrench
Medium Pipe Wrench
Crow Bar For Shim Installation
Chalk Line
Medium Flat Screwdriver
Tape Measure: 25 Foot Minimum
Needle Nose Pliers
IMPORTANT NOTICE
These instructions must be followed to insure proper installation and operation of your lift. Failure
to comply with these instructions can result in serious bodily harm and void product warranty.
Manufacturer will assume no liability for loss or damage of any kind, expressed or implied resulting
from improper installation or use of this product.
PLEASE READ ENTIRE MANUAL PRIOR TO INSTALLATION.
NOTE
All models MUST be installed on 3000 PSI
concrete only conformIng to the minimum
requirements shown above. New concrete must be
adequately cured by at least 28 days minimum.
7
To Next Page
Loading...
