BendPak XPR-9S User Manual

1
INSTALLATION AND OPERATION MANUAL
RECEIVING
The shipment should be thoroughly inspected as soon as it
is received. The signed Bill of Lading is acknowledgement
by the shipping carrier as receipt of this product as listed
in your invoice as being in a good condition of shipment. If
any of these goods listed on this Bill of Lading are missing
or damaged, do not accept goods until the shipping car-
rier makes a notation on the freight bill of the missing or
damaged goods. Do this for your own protection.
BE SAFE
Your new lift was designed and built with safety in mind.
However, your overall safety can be increased with
proper training and thoughtful operation on the part of the
operator. DO NOT operate or repair this equipment
without reading this manual and the important safety
instructions shown inside. Keep this operation manual near
the lift at all times. Make sure that ALL USERS read and
understand this manual.
1645 Lemonwood Dr.
Santa Paula, CA. 93060, USA
Toll Free 1-800-253-2363
Tel: 1-805-933-9970
Fax: 1-805-933-9160
www.bendpak.com
9,000 LB / 4.082 KG CAPACITY
SURFACE MOUNTED TWO-POST LIFTS
MODELS:
XPR-9S
XPR-9S-LP
XPR-9TS
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
PLEASE READ THE ENTIRE CONTENTS OF THIS MANUAL PRIOR
TO INSTALLATION AND OPERATION. BY PROCEEDING WITH LIFT
INSTALLATION AND OPERATION YOU AGREE THAT YOU FULLY
UNDERSTAND AND COMPREHEND THE FULL CONTENTS OF THIS
MANUAL. FORWARD THIS MANUAL TO ALL OPERATORS. FAILURE TO
OPERATE THIS EQUIPMENT AS DIRECTED MAY CAUSE INJURY OR DEATH.
MAN REV C 07-15-2016
P/N 5900371
400V 50Hz SUPPLY DETAILS ARE
INCLUDED WITH ELECTRICAL
CONTROL BOX. DISREGARD SUPPLY
WIRING DETAILS IN THIS MANUAL
EUROPEAN USERS
ORIGINAL INSTRUCTIONS IN
ENGLISH LANGUAGE

BendPak XPR-9S Specifications

General

Rise Time	45 seconds
Motor	2 HP
Lifting Capacity	9, 000 lbs
Minimum Height	4.5 inches
Power Requirements	220 VAC / 60 Hz / 1 Ph

Summary

Safety and Operation Guidelines

Important Safety Instructions

Essential warnings and guidelines for safe use of the lift.

Owner's Responsibilities and Hazard Definitions

Duties of owners and explanation of hazard levels and signal words.

Installer/Operator Protective Equipment

Recommendations for personal safety gear during installation and operation.

Lift Operation Safety Guidelines

Procedures for safely operating the lift with vehicles.

Safe Lift Operation Principles

Core practices for secure and efficient lift operation.

Installation Guide

Site Selection, Floor Requirements, and Tools

Guidance on choosing a location, floor specifications, and necessary tools.

Parts Inventory and Layout Planning

Verifying components and planning the lift's physical arrangement.

Floor Plan and Specifications

Dimensions, clearances, and model-specific technical data.

Post and Power Unit Installation Steps

Detailed steps for assembling posts, mounting the power unit, and routing lines.

Lift Arm, Cable, and Leveling Procedures

Installing lift arms, equalizer cables, and ensuring proper leveling.

Power Unit Connection and Start-Up

Connecting electrical supply and performing initial operational checks.

Post-Installation Checks

Final verification of installation and safety systems.

Maintenance and Troubleshooting

Lubrication and Routine Maintenance

Procedures for lubricating components and scheduled checks.

Wire Rope Inspection and Maintenance

Guidelines for checking and maintaining lifting cables.

Troubleshooting Common Lift Issues

Diagnosing and resolving problems like no-raise or motor issues.

Torque Recommendations and Records

Specifications for bolt tightening and maintenance logging.

Accessories, Compliance, and Documentation

Optional Accessories and Installation

Details on available accessories and their installation.

Installation Form and Compliance Documents

Forms for recording installation and conformity certificates.