EasyManua.ls Logo

BendPak XPR-9 User Manual

BendPak XPR-9
48 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
1
INSTALLATION AND OPERATION MANUAL
RECEIVING
The shipment should be thoroughly inspected as soon as it
is received. The signed Bill of Lading is acknowledgement
by the shipping carrier as receipt of this product as listed
in your invoice as being in a good condition of shipment. If
any of these goods listed on this Bill of Lading are missing
or damaged, do not accept goods until the shipping carrier
makes a notation on the freight bill of the missing or dam-
aged goods. Do this for your own protection.
BE SAFE
Your new lift was designed and built with safety in mind.
However, your overall safety can be increased with proper
training and thoughtful operation on the part of the operator.
DO NOT operate or repair this equipment without reading
this manual and the important safety instructions shown
inside. Keep this operation manual near the lift at all times.
Make sure that ALL USERS read and understand this
manual.
1645 Lemonwood Dr.
Santa Paula, CA. 93060, USA
Toll Free 1-800-253-2363
Tel: 1-805-933-9970
Fax: 1-805-933-9160
wwwbendpak.com
9,000 POUND CAPACITY
SURFACE MOUNTED
TWO-POST LIFTS
MODELS:
XPR-9
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
PLEASE READ THE ENTIRE CONTENTS OF THIS MANUAL PRIOR TO
INSTALLATION AND OPERATION. BY PROCEEDING WITH LIFT
INSTALLATION AND OPERATION YOU AGREE THAT YOU FULLY
UNDERSTAND AND COMPREHEND THE FULL CONTENTS OF THIS MANUAL.
FORWARD THIS MANUAL TO ALL OPERATORS. FAILURE TO OPER-
ATE THIS EQUIPMENT AS DIRECTED MAY CAUSE INJURY OR DEATH.
MAN REV A 1-10-11
P/N 5900048
Question and Answer IconNeed help?

Do you have a question about the BendPak XPR-9 and is the answer not in the manual?

BendPak XPR-9 Specifications

General IconGeneral
BrandBendPak
ModelXPR-9
CategoryLifting Systems
LanguageEnglish

Summary

Important Safety Instructions

Safe Operation Mandate

Emphasizes reading the entire manual for safe operation and understanding hazards.

Owner's Responsibilities

Installer and Operator Guidelines

General Safety Instructions

Step 1: Site Selection

Step 2: Floor Requirements

Step 3: Post Preparation

Step 4: Site Layout

Step 5: Installing Power Side Post

Step 6: Installing Off Side Post

Step 7: Mounting Hydraulic Power Unit

Step 8: Installing Safeties and Safety Cable

Step 9: Installing Hydraulic Lines

Step 10: Routing Equalizer Cables

Step 12: Installing Lift Arms

Important Leveling Instructions

Power-Unit Installation Notes

Step 13: Power Unit Connection

Step 14: Lift Start Up and Adjustments

Post-Installation Checklist

Step 15: Lubrication

Step 16: Operation Instructions

General Lift Operation Safety

Key safety rules for operating the lift.

Required Monthly Maintenance

Wire Rope Inspection and Maintenance

Safe Lift Operation Overview

Lift Operation and Safety Practices

Essential safety practices and considerations for lift operation.

Troubleshooting: Lift Will Not Raise

Troubleshooting: Motor Will Not Run

Troubleshooting: Slow Lowering

Troubleshooting: Lift Will Not Raise Loaded

Troubleshooting: Lift Will Not Stay Up

Installation Form

Related product manuals