BendPak XPR-9F - User Manual

INSTALLATION AND OPERATION MANUAL
SHIPPING DAMAGE CLAIMS
When this equipment is shipped, title passes to the
purchaser upon receipt from the carrier. Consequently,
claims for the material damaged in shipment must be
made by the purchaser against the transportation
company at the time shipment is received.
BE SAFE
Your new lift was designed and built with safety in mind.
However, your overall safety can be increased by proper
training and thoughtful operation on the part of the operator.
DO NOT operate or repair this equipment without reading this
manual and the important safety instructions shown inside.
1645 Lemonwood Dr.
Santa Paula, CA. 93060, USA
Toll Free: 1-800-253-2363
Tel: 1-805-933-9970
Fax: 1-805-933-9160
wwwbendpak.com
Keep this operation manual near the
machine at all times. Make sure that
ALL USERS read this manual.
9,000 POUND CAPACITY
SURFACE MOUNTED
TWO-POST LIFTS
MODELS:
XPR-9F
XPR-9FX
VERSION A
PLEASE READ THE ENTIRE CONTENTS OF THIS MANUAL PRIOR TO
INSTALLATION AND OPERATION. BY PROCEEDING YOU AGREE THAT
YOU FULLY UNDERSTAND AND COMPREHEND THE FULL CONTENTS OF
THIS MANUAL. FORWARD THIS MANUAL TO ALL OPERATORS. FAILURE TO
OPERATE THIS EQUIPMENT AS DIRECTED MAY CAUSE INJURY OR DEATH.
REV C 06.-18-09

BendPak XPR-9F Specifications

General

Lifting Capacity	9, 000 lbs
Lifting Height	72 inches
Max Rise	72 inches
Overall Width	132" / 3, 353 mm
Overall Length	117" / 2, 972 mm
Drive-Thru Clearance	96" / 2, 438 mm
Lifting Time	45 seconds
Motor	2 HP
Voltage	220V
Warranty	1 Year

Summary

Product Warranty

Owners Responsibility

Installer; Operator Safety

Installer; Operator Protective Equipment

Introduction

Important Safety Instructions

Crucial safety guidelines to be read and followed before operation.

Step 2: Floor Requirements

Concrete Specifications

Parts Inventory

Step 3: Lifting Chain Installation

Connecting the Lifting Chain to the Lift Head

Step 4: Preparing the Columns

Step 5: Site Layout

Step 6: Installing Powerside Column

Step 7: Installing The Offside Column

Step 8: Mounting the Hydraulic Power Unit

Step 9: Installing the Safeties and Safety Cable

Step 10: Installing Hydraulic Lines

Step 11: Routing the Equalizer Cables

Step 12: Installing Safety Covers

Step 13: Installing the Lift Arms

Important Leveling Instructions

Important Power-Unit Installation Notes

Step 14: Power Unit Hook Up

Step 15: Lift Start Up; Final Adjustments

Post-Installation Check-Off

Step 16: Lubrication

Step 17: Operation

To Raise Lift

Procedure for safely raising the vehicle on the lift.

To Lower Lift

Procedure for safely lowering the vehicle from the lift.

Wire Rope Inspection and Maintenance

When to Replace Lifting Cables Due to Broken Wires

Safe Lift Operation Guidelines

Training Requirements

Essential training components for safe lift operation.

Lift Operation Safety Procedures

Critical safety procedures for operating the lift.

Troubleshooting: Lift Will Not Raise

Troubleshooting: Motor Issues

Troubleshooting: Lift Will Not Raise Loaded

Troubleshooting: Lift Will Not Stay Up

Possible Cause

Identifies potential reasons why the lift may not maintain its position.

Remedy and Instructions

Provides solutions for issues related to the lift not staying up.

Installation Form

Pre-Install Agreement

Post-Installation Check-Off