BendPak XPR-9TS User Manual

1
INSTALLATION AND OPERATION MANUAL
RECEIVING
The shipment should be thoroughly inspected as soon as it
is received. The signed Bill of Lading is acknowledgement
by the shipping carrier as receipt of this product as listed
in your invoice as being in a good condition of shipment. If
any of these goods listed on this Bill of Lading are missing
or damaged, do not accept goods until the shipping car-
rier makes a notation on the freight bill of the missing or
damaged goods. Do this for your own protection.
BE SAFE
Your new lift was designed and built with safety in mind.
However, your overall safety can be increased with
proper training and thoughtful operation on the part of the
operator. DO NOT operate or repair this equipment
without reading this manual and the important safety
instructions shown inside. Keep this operation manual near
the lift at all times. Make sure that ALL USERS read and
understand this manual.
1645 Lemonwood Dr.
Santa Paula, CA. 93060, USA
Toll Free 1-800-253-2363
Tel: 1-805-933-9970
Fax: 1-805-933-9160
www.bendpak.com
9,000 LB / 4.082 KG CAPACITY
SURFACE MOUNTED TWO-POST LIFTS
MODELS:
XPR-9S
XPR-9S-LP
XPR-9TS
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
PLEASE READ THE ENTIRE CONTENTS OF THIS MANUAL PRIOR
TO INSTALLATION AND OPERATION. BY PROCEEDING WITH LIFT
INSTALLATION AND OPERATION YOU AGREE THAT YOU FULLY
UNDERSTAND AND COMPREHEND THE FULL CONTENTS OF THIS
MANUAL. FORWARD THIS MANUAL TO ALL OPERATORS. FAILURE TO
OPERATE THIS EQUIPMENT AS DIRECTED MAY CAUSE INJURY OR DEATH.
MAN REV C 07-15-2016
P/N 5900371
400V 50Hz SUPPLY DETAILS ARE
INCLUDED WITH ELECTRICAL
CONTROL BOX. DISREGARD SUPPLY
WIRING DETAILS IN THIS MANUAL
EUROPEAN USERS
ORIGINAL INSTRUCTIONS IN
ENGLISH LANGUAGE

BendPak XPR-9TS Specifications

General

Brand	BendPak
Model	XPR-9TS
Category	Lifting Systems
Language	English

Summary

Important Safety Instructions

Owner and Operator Responsibilities

Outlines owner and operator duties for safe installation and operation.

Definitions of Hazard Levels

Explains signal words (Danger, Warning, Caution) and their meanings.

Installer/Operator Protective Equipment

Details recommended personal protective equipment for safe work.

General Safety Instructions

Provides essential safety guidelines to follow before operating the lift.

Installation and Operation Manual

Introduction and Tools Required

Covers manual introduction, safety precautions, and necessary tools for installation.

Site Selection and Floor Requirements

Specifies criteria for choosing a suitable installation site and concrete floor.

Parts Inventory

Lists components and provides an assembly view for identification.

Key Installation Steps

Covers critical steps from post preparation to lift arm installation.

Post-Installation Check-Off and Lubrication

Lists final checks and lubrication procedures after installation.

Lift Operation Safety

General Lift Operation Safety Guidelines

Comprehensive safety guidelines for operating the lift with vehicles.

Wire Rope Inspection and Maintenance

Details procedures for inspecting and maintaining lifting cables.

Safety Pictographs and Warnings

Illustrates common safety pictographs and their meanings.

Troubleshooting and Maintenance

Lift Operation Troubleshooting

Addresses common problems like lift not raising, motor issues, or slow operation.

Torque Recommendations

Provides torque values for various bolt sizes during installation and maintenance.

Maintenance Records and Installation Form

Space for recording maintenance and an installation completion form.

Certifications and Documentation

Declaration of Conformity

States the equipment conforms to EU Machinery Directive and relevant standards.

EC Type-Examination Certificate

Official certificate confirming compliance with EU type-examination standards.