BendPak XP-10CX - User Manual

INSTALLATION AND OPERATION MANUAL
SSHHIIPPPPIINNGG DDAAMMAAGGEE CCLLAAIIMMSS
When this equipment is shipped, title passes to the
purchaser upon receipt from the carrier. Consequently,
claims for the material damaged in shipment must be made
by the purchaser against the transportation company at the
time shipment is received.
BBEE SSAAFFEE
Your new lift was designed and built with safety in
mind. However, your overall safety can be increased
by proper training and thoughtful operation on the part
of the operator. DO NOT operate or repair this equip-
ment without reading this manual and the important
safety instructions shown inside.
1645 Lemonwood Dr.
Santa Paula, CA. 93060, USA
Toll Free 1-800-253-2363
Tel: 1-805-933-9970
Fax: 1-805-933-9160
Keep this operation manual near the
machine at all times. Make sure that
ALL
USERS read this manual .
10,000 POUND CAPACITY
12,000 POUND CAPACITY
15,000 POUND CAPACITY
18,000 POUND CAPACITY
SURFACE MOUNTED
TWO-POST LIFTS
MODELS:
XP-10C
XP-10CX
XP-10AC
XP-10ACX
XP-12CTA
XP-15C
XP-18C
PLEASE READ THE ENTIRE CONTENTS OF THIS MANUAL PRIOR TO
INSTALLATION AND OPERATION. BY PROCEEDING YOU AGREE THAT YOU
FULLY UNDERSTAND AND COMPREHEND THE FULL CONTENTS OF THIS
MANUAL. FORWARD THIS MANUAL TO ALL OPERATORS. FAILURE TO
OPERATE THIS EQUIPMENT AS DIRECTED MAY CAUSE INJURY OR DEATH.
REV B 10-24-07

Summary

Installer; Operator

Step One (Selecting Site)

Step Two (Floor Requirements)

Specifies the necessary concrete specifications and floor conditions for safe installation.

Step Three (Site Layout)

Step Four (Installing The POWERSIDE Column)

Step Five (Mounting The OFFSIDE column.)

Step Six (Mounting the OVERHEAD BEAM.)

Instructions for installing the overhead beam connecting the two columns.

Step Seven (Mounting The POWER UNIT)

Step Eight (Installing the safeties and safety cable)

Step Nine (Installing The HYDRAULIC LINES.)

Step Ten (Routing The EQUALIZER CABLES)

Instructions for properly routing the equalizer cables between carriages.

Important Power-Unit Installation Notes

Step Eleven (Installing Overhead MICRO SWITCH.)

Step Twelve (Power Unit Installation and Start-Up.)

Important Leveling Instructions

Post-Installation Check-Off

Step Thirteen (Lift Start Up; Final Adjustments)

Step Fourteen (Installation Of SAFETY COVER.)

Lubrication

Start-Up and Bleeding

Operation

To Raise Lift

Steps for safely positioning and raising a vehicle on the lift.

To Lower Lift

Steps for safely lowering a vehicle from the lift.

Safe Lift Operation

Lift Operation Safety

Key safety points and precautions during lift operation.

Lift Will Not Raise

Motor Will Not Run

Lift Lowers Slowly or Not At All

Will Not Raise Loaded Lift

Lift Will Not Stay Up

BendPak XP-10CX Specifications

General

Brand	BendPak
Model	XP-10CX
Category	Lifting Systems
Language	English