21
Shooting with the shotgun
Before carrying out any type of inter-
vention on the shotgun, always make
sure that the chamber, carrier and
magazine are completely empty! (Care-
fully read the instructions for loading and
unloading the shotgun).
Warning: Observe all safety practices
at the beginning of this manual.
1. Move the safety button to the “re”
position.
2. Place your nger on the trigger and pull
it back to re the gun.
3. The bolt will unlock automatically af-
ter ring.
4. Moving the fore-end fully back will ex-
tract and eject the red round and re-
lease a new round from the magazine
onto the carrier.
5. Moving the fore-end fully forward will
chamber the next round for ring.
6. The trigger must be released and al-
lowed to re-set before the next round
can be red.
7. Pulling the trigger will re the cham-
bered round, and the cycle can be re-
peated until all rounds loaded in the
shotgun have been red.
8. After ring: put the safety in the “ON”
(safe) position, open the bolt by slid-
ing the fore-end all the way back; visu-
ally and physically check the cham-
ber, carrier and magazine to be sure
the rearm is completely unloaded.
Cartridge replacement
(Perform this operation with the gun
safety catch “on”- see “Shotgun safe-
ty” - and the barrel pointing in a safe
direction)
The round in the chamber may be manu-
ally replaced with a different round from
the magazine or another round.
Regarding the selected rearm operation,
it is possible to proceed as follows:
1. Open the bolt, moving back the fore-
end; the chambered cartridge is ex-
tracted and ejected from the rearm,
while the rst cartridge in the magazine
automatically drops onto the carrier.
2. Move the bolt back to the closed posi-
tion using the fore-end lever; while it
closes, the bolt chambers the cartridge
on the carrier and stops in a closed po-
sition.
▀
Replacement with a cartridge not
from the magazine
1. Push the carrier inside the shotgun and
at the same time, open the bolt by pull-
ing the fore-end lever. The cartridge in
the chamber is ejected by the extractor
but no cartridge is fed from the maga-
zine.
2. Insert the new cartridge, even partially,
into the chamber through the ejection
port and close the bolt by pushing the
fore-end lever forward. When closing,
the bolt chambers the partially inserted
cartridge and comes to a stop in the
closed position.
To Next Page
Loading...